ABS and Brake light came on after replacing the hub assembly and brake shoes code p1332. Please help me thank you.
What the problem your ABS/brake light is on .......or your code p1332 witch has nothing to do with your brake ...p1332 is a (vvt) variable valve timing
If you need further help, reach me via phone at https://www.6ya.com/expert/dennis_f849d3d6a68c6430
SOURCE: 2001 v 70 volvo brake light
Hello. Check relay RMI5 in REM unit located in left side rear of cargo area. As you look at it it's to the right of the central electrical connector 5th from bottom. Matt
SOURCE: 2003 Volvo S60 AWD warning brake failure light
Check the fuse and the wirings.
I’m happy to assist further over the phone at https://www.6ya.com/expert/ramy_d9e7ebea3891f482
SOURCE: My A.B.S light stays on, on my Volvo C70 coupe , i
you need new abs module that is your problem
SOURCE: How do I replace the brake light bulb in a volvo
This would be a bulb problem. You can open up your trunk, pull back the liner, and find the screws that hold the lens on, remove the screws, pry off lens and then push in and turn counter clockwise to remove the bulb. Then the new bulb pushes in and turns clockwise to lock in place.
Testimonial: "Thanks so much I will try this!"
SOURCE: replace brake light 850 volvo wagon
It is really easy, and requires no tools. There is a flush panel inside the car behind the lights, using fingernails pry it off, then all the bulbs are visible and quickly changed out.
Adjustment
Removal & Installation
NOTE
The following procedure may be used to remove shoes on either side of the vehicle.
Fig. View of the actuator (1), support (2), adjuster spring (3), return spring (4), caliper adapter (5), shoes (6), hold-down clips and pins (7) and adjuster (8)
Adjustment
This vehicle is equipped with permanently sealed rear wheel bearings. There is no periodic lubrication or maintenance recommended for these units.
Removal & Installation
Fig. Hub assembly
Fig. Rear hub and bearing mounting bolts
224 views
Usually answered in minutes!
×