2005 mustang blower motor resistor location - 2005 Ford Mustang V6

should be just above the blower motor. You will need to remove the glove box door to gain access.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The blower motor resistor is located under the dash on the passengers side between the blower motor and the fire wall. You will need to remove the hush panel first, also if you remove the blower motor the resistor will be easier to replace.

normally in the blower motor enclosure as it uses air flow to help cool the resistors

check the connections at the rear of the control panel . check for power at resistor there is a blower relay

Might be the Resistor pack located close to the blower. It has a flat connector with 4 or 5 wires, and two small screws holding in the duct. It may be a crispy critter. It happens... The blower moves air across it to keep it cool. The blower motor may be bad as well, or possibly the fan speed switch. May very well be the fuse for the blower as well. The blower connector may be loose. Let me know what you find.

It should be mounted on the blower box,near the blower motor to keep it cool,it mounts on the out side,but actually goes inside the blower box,it has a multi wire connector to it.

if you are getting only one speed from the blower motor then it would be the (blower motor resistor) causeing the problem. the blower motor resistor is located under the dash on the passenger side next to the blower motor. unplug connector and remove two screws from housing. to test the resistor connect a continuity tester to the resistor. check between the input to the output sides of the resistor for continuity. if not replace the resistor.

Your blower speed resistor has gone bad and needs to be replaced. You can pick one up at Auto Zone or Parts Source with the step by step instructions to getting the resistor replaced with common tools.

It is located under the glove box, way in the back of the passenger foot area. You'll need to remove 2 screws with a 7mm socket, and remove the plastic cover that covers the blower motor and another component box that I think controls the passenger airbag. After removing the plastic cover you'll need to side that passenger airbag module to the right so it pop off its mounting bracket and move it out of the way. That will give a better view of the blower motor. I highly recommend you also remove the blower motor itself because the Blower Motor Resistor is located behind it. I think you'll need a 5mm or 5.5mm socket to remove the 3 screws that hold in place the blower motor and 2 more screws for the Blower Motor Resistor... It's a cramped location to work in but if you have all the tools and enough lighting then it shouldn't take more than 30-60 minutes to do. The Blower Motor Resistor costs about $19-$25. Good luck

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.