Unless you have seen the inside of the door this is a guessing game but it can be done by feel. Place the slim jim in the middle of the window between the wiper and the glass. Put it as far down as you can and slide it around until you feel the mechanism. From there it is gently pulling, sliding and caressing it until it pops. If you can see the manual lock on the inside then you can watch for the to jiggle and you know you are in the right spot.
If you are using the slim Jim on driver door your mechanism is on the far right side of the door. You will feel it hook but might not see the mechanical lock on interior of the door move at all... It took some force to get it too move but in a upward motion I just pull kinda hard and it popped right open. Good luck!
×
SOURCE: how to change the serpentine belt on a lumina euro 3.1??
I found on my 92 lumina 3.1 the easiest way to change the belt is to have two people handy (you and a helper) push the belt tensioner (which is more in the middle of the belt system, its the only thing that has give when pressure is applied) down (which will loosen the belt) have your partner slip the belt off the altenator (which should be on the very top of the belt system on the passenger side) and just pay attention to the way the belt is routed as you remove it, put the new one on (routed correctly) push the tensioner again have your partner slip it back over the altenator....and you have a new belt on with no tools :)
just pay good attention to the routing of the belt, and i also think there is a black cover over the belt which needs to be removed before the old belt can be taken off (if you dont see it at first you will find it) it has 3 bolts i think and also a diagram of the routing....
TIP: the tensioner will take some muscle to move down, and yes the belt is running over it....
SOURCE: fuel filter
depending on which motor you have it will be tucked up by the gas tank or on the drivers side body rail
SOURCE: want to know firing order
Firng order is 1-2-3-4-5-6
Diagram shows how to hook up coils, just match the numbers up.
you have to wedge the weatherstripping out with a wedge.then what you need is a good sturdy piece of wire(not a clotheshanger)on one end make you a hook in the shape of a (u) push your wire down about 5 inches in the gap closer to middle of the door when you hook the rod turn your wire clockwise and it should pop your lock
396 views
Usually answered in minutes!
×