My 2001 Chevy Tracker has lost highbeams when I push the switch. When I pull the switch, it works, and when I push the switch sometimes it comes on and work a couple times after. Also if it is the dimmer switch. I need to steps to replace it.

You have bad switch if it were a bcm you would lose all of your lights

it may be the sensor if it has one or it may be the unit it self

Go under the vehicle and check the four wheel drive linkage.

2001 Chevy Tracker 6 cyl Four Wheel Drive Automatic

My 4 wheel drive stop working on my 2001 ZR2 chevrolet Tracker. It has a shifter on the floor and when it is put into 4 hi or 4 lo. the vehicle does not change from two wheel drive into 4. The 4x4 Dash light indicator stop coming on. What should I check?
I lost 4x4 traction when driving in icy conditions.

Hi, here is the location of the fuel pump replay below....



Hope it helps....

If your Highbeam Switch is on your streering colum (turn signal lever) Thats where I would start too look! It could be the wires to the highbeam switch. I had that happen on my ford. But if the highbeam switch is on the floor, check for a bad circut connection and if that checks ok it might be your main headlight switch! Even though you may not loose your highbeams, your main headlight power still runs through that highbeam switch, and being on the colum thats why the would start to function when you move the shifter.

ny front axle when you are drivin it in 4 high it pulls to the right and it makesa noise

I've had this happen to me. It's a bad bulb with a broken filament the makes and brakes. If when you check the bulb and it's ok than look to the plug on the rear of the bulb possibly not making contact. Good luck.

Should change drivers front switch. If neither rears work and main switch don operate them then it is the drivers control that is bad.

The lights will turn on automatically in a minute or so after you start the vehicle. Their on all the time, when motor is running. To turn on manually ( I have a tracker) left switch (turn signal switch) turn nob on end of switch also to change from bright to dim pull turn switch towards driver gently.