2011 mini cooper countryman, starts, runs, drives but has low power.(50 mph ) max Due for service in 1200 miles.

mini cooper s heat not working - North American Motoring

www.northamericanmotoring.com/...2006/243158-mini-cooper-s-heat-n...

Jan 2, 2013 - mini cooper s heat not working R50/R53 :: Hatch Talk (2002-2006) ...Any way to determine if the heater core is clogged? And could it be ... Overheating issue / heater not working
Jan 18, 2012
No Heat!!!
Nov 5, 2011
2008 MC Heater Problem
Nov 2, 2008
Heater stops working at idle, Engine overheating light comes on at ...
Apr 10, 2008
More results from www.northamericanmotoring.com

MINI COOPER 07 heater blowing cold air-HELP - MINI Cooper Forum

www.mini2.com > ... > Second Generation Faults & Fixes

Mar 6, 2010 - I too have a 2007 Mini Cooper with heater problems. It now has 96,000 miles and I have just started having this problem. Heater will not blow out hot air bottom or top vents when ideling or low speeds .... Join Date: Nov 2006. Heating not working - mini one 02plate - MINI Cooper Forum
May 15, 2012
2002 Cooper S lukewarm heater - MINI Cooper Forum - Mini2.com
Oct 25, 2011
Problem with heater blower - and no resistor pack to be found ...
Mar 21, 2011
mini cooper 02 HEATER NOT WORKING? - MINI Cooper Forum
Jan 19, 2010
More results from www.mini2.com

Heat not working, MINI overheating! - Motoring Alliance :: MINI ...

www.motoringalliance.com > ... > 1st Generation MINI > Cooper S

Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?

http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?

http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?

http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

you would need to scan the computer and see what codes you have to start this should still be under factory warr being a 2011 unless you have a lot of miles on it

Low oil no. Low water yes simply check the water. I don't think the temperature sensor is bad. The problem is probably due to the car running hotter.

I had a similar issue and it ended up being a broken wheel bearing. I even ended up having two, one was broken on my front passenger side, and one broken on my rear driver side. The part costs about $280.00, but could cost around $400.00 with service repair. The noise of a broken wheel bearing can sound like a humming, and over time it becomes louder. The car can be driven with a broken wheel bearing, but doing so can eventually lead to other wheel/tire maintenance. MINI's endure this commonly due to their low profile to the ground. Here is a forum on further issues experienced, including the bearing, and efforts towards recalls. http://newmini.wordpress.com/2009/02/17/mini-cooper-power-steering-failure/#comment-884

I need to replace the transmission in a 2005 mini cooper can I replace the 5 speed with a 6 speed?

have you checked transmission oil?
I am not familar with MINI's but it sounds like either your transmission oil is low or is too thick (cold weather could do that) that the computer is safe gaurding you for destroying your transmission or you computers messed up.

Recommendation: get the car to a shop ASAP before you do serious damage.

you have to run at 1-3 mph speed, to remove it from low

50 MPH in 4WD don't exceed you ll burn the transfer case clutches. (Safely stay at 40, why chance it.)

Low 4WD 25 MPH is the max, I recommend no more that 15MPH

Burnt clutches in transferr case 1200 job at the dealer, includes new clutch pack and fluid and 3 days of work, one or two days if you are lucky depending on their work load. (Read your manual)

This is the flat tire light. either your tires are low on pressure or the flat tire light button is stuck down. if your tires are low refill to same pressure I usually use 35 psi. then start the car stay parked. depress the flat tire button located either under the ebrake or just to the right of the ebrake. hold for 10 sec. then drive car for 5-10 min do not drive hard. drive on normal roads 25 -35 mph then drive on the highway. If the button is stuck find some kind of electrical cleaner and just keep trying to clean it till it no longer sticks down.