Am trying to check the cam and crank timing alignment
SOURCE: Correct way to align timing marks
hi -- the timing marks on a twin cam are tricky!! heres how- turn the motor over to tdc on the bottom pulley,this will align two marks on the lower cog-----now on the top cog,it has an obvious mark near the teeth-- well disregard this for now!! the cog has a hole in it,in one of the spokes,well this goes at 12 o,clock and lines up with a mark you will see on the housing! now if you are right you will see the mark near the teeth is at around 4,oclock---i just did one and it is right--cheers
SOURCE: timing marks for 2000 hyundai elantra
The crank sprocket has a white mark that lines up with a line behind it cast into the oil pump cover. The camshaft sprocket has a marking that says UP with a hole. Use the hole to sight the timing mark on the cam bearing cap behind the sprocket.
SOURCE: Timing Belt Markings
Mark are on the crank and cam timing gears. Cam gear mark at 12 o"clock crank gear mark lined up with TGC mark on block when installing timing belt.
SOURCE: Timing marks setting Hyundai Lantra
Installation
Ensure timing marks aligned [6] & [7] . 1. Fit timing belt in anti-clockwise direction, starting at crankshaft sprocket. Ensure belt is taut between sprockets. 2. Slacken tensioner pulley bolt [8] . Push tensioner pulley firmly against timing belt to tension belt. 3. Tighten tensioner pulley bolt [8] . Tightening torque: 43-55 Nm. 4. Except Matrix: Turn crankshaft one turn clockwise. 5. Matrix: Turn crankshaft two turns clockwise. 6. Ensure timing marks aligned [6] . 7. Apply a load of 2 kg to belt at . Belt should deflect 4-6 mm. If not: Adjust position of tensioner pulley. 8. Install components in reverse order of removal. 9. Tighten crankshaft pulley bolt [2] . Tightening torque: 170-180 Nm
7 is timing mark on cam,pin mark to top,hole in spoke below pin mark lines up with mark on head
6 is crank timing mark,pin mark on crank lines up with mark on block
NOTE this mark is just before top
1,160 views
Usually answered in minutes!
×