Question about Hyundai Accent
Shut off fuel pump
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
Posted on Jan 08, 2009
A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.
Posted on Apr 22, 2009
One of two places. Look in trunk bolted to fender well, you will have to pull back carpet. OR On passenger side kick panel under dash. Basiclly if you were sitting in pass seat it would be right next your right foot again pull back carpet.
either place the switch will be a push/reset button.
Posted on Jun 21, 2009
Tips for a great answer:
Aug 02, 2016 | 2005 Hyundai Accent
May 13, 2015 | Hyundai Cars & Trucks
Mar 31, 2015 | 2005 Hyundai Accent
Nov 08, 2014 | Cars & Trucks
Mar 10, 2014 | 1996 Hyundai Accent
Sep 16, 2011 | 2003 Hyundai Accent
Apr 11, 2011 | Hyundai Tucson Cars & Trucks
Feb 26, 2011 | 2005 Hyundai Accent
Jun 28, 2010 | 2003 Hyundai Accent
26 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: