At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The camshaft position sensor is always located near the camshaft, often at the top of the valve cover, but it can also be installed from the side of the cylinder head.
Check around the head or valve cover and follow any electrical wires and you will for sure find the camshaft position sensor.
Which one ?
Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on top of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The camshaft position sensor is either located near the top of the engine, passenger-s side, or on the right side of the engine near the ignition coils.
The camshaft position sensor is located on the engine near the camshaft pulley.
This sensor is located at the front of the engine near the camshaft gear this is what I got 6 different locations manual covers 99-05
2.0L 2.4L RemovalThe camshaft position sensor is mounted to the rear of the cylinder head. Remove the negative battery cable.Disconnect the PCV hose and repositionDisconnect electrical connectors from the camshaft position sensor.Remove camshaft position sensor mounting screws.Remove sensor.Loosen screw attaching target magnet to rear of camshaft and remove magnet. InstalationThe target magnet has locating dowels that fit into machined locating holes in the end of the camshaft. - Install target magnet in end of camshaft. Tighten mounting screw to 3 Nm (30 in. lbs.) torque. Over torqueing could cause cracks in magnet. If magnet cracks replace it. - Install camshaft position sensor. Tighten sensor mounting screws to 12.9 Nm (115 in. lbs.) torque. - Carefully attach electrical connector to camshaft position sensor. Installation at an angle may damage the sensor pins.- Connect the PCV Valve hose.- Connect the negative battery cable. 2.7L V6 Removal The camshaft position sensor is mounted in the front of the head. Disconnect electrical connector from sensor.Remove camshaft position sensor screw. CAM Sensor Location 2.7L Without pulling on the connector, pull the sensor out of the chain case cover. Installation- Install sensor in the chain case cover and push sensor in until contact is made with the boss on the head. While holding the sensor in this position,install and tighten the retaining bolt to 12 Nm (105 in. lbs.) torque. - Attach electrical connector to sensor. Good luck and hope this helps
×