2007 Dodge Nitro SLT Logo

Related Topics:

A
Anonymous Posted on Feb 10, 2015

HOW DO I REPLACE AC CONDENSER ON 2007 DODGE NITRO

1 Answer

Bob R Parks

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Contributor 38 Answers
  • Posted on Sep 14, 2016
Bob R Parks
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

Joined: Feb 26, 2015
Answers
38
Questions
0
Helped
20374
Points
75

You can't it needs to be done by a dealer, they have to
Evac all the old R134 and replace unit and then fill with all new oil and R134. Expensive fix.

5 Related Answers

Anonymous

  • 490 Answers
  • Posted on Apr 14, 2009

SOURCE: 2007 dodge nitro power passenger window won't work

change the window motor

Ad

Anonymous

  • 2049 Answers
  • Posted on Aug 08, 2009

SOURCE: where is the oil filter on a 2007 dodge nitro v6

You can access the oil filter easily from underneath next to the front, driver-side wheel at the front of the engine. There is clear access to the filter there.

For more info on Dodge Nitro, visit the forum at
http://www.dodge-nitro.com/dodge-nitro/

Anonymous

  • 880 Answers
  • Posted on Jan 01, 2010

SOURCE: I need a serpentine Belt diagram for a 2007 Dodge

This link should help you. Also you vehicle came from the factory with a diagram under the hood somewhere.
http://www.aa1car.com/library/serpentine_belt.htm

Mike

  • 4383 Answers
  • Posted on Jun 28, 2010

SOURCE: how do you replace the ac condenser on a 98 dodge

This job requires special tools and special training. If you lack either, you risk SERIOUS personal injury. Injury comes VERY EASILY!

You need to address oil levels, proper and legal refrigerant recovery, system evacuation, and recharge.

You were planning to also replace the receiver/dryer, correct? It also needs the oil in it measured and incorporated into the amount of oil (in %) that would need to be added. FAILURE to address these and other issues will guarantee premature system failure and likely compressor damage.

Take this job to a qualified shop.

Sorry

tedww

Theodore Warren

  • 111 Answers
  • Posted on Feb 23, 2011

SOURCE: need to replace fuse for cigarette lighter on 2007

if you look under your dash on the drivers side, you should find a little door or hatch. after you open it look on the back of the door for a diagram of the fuses...one should be labeled for the lighter, or accessory power outlet. use a pair of needle nose pliers to pull the bad fuse and push in the new one.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My door handle broke, so I bought a new one, I cant figure out how to take the broken handle off. A 2007 Dodge Nitro.

Remove door panel, then unbolt handle. Verify no screws in door panel then yank. Screws probably in armrest and by door handle, maybe under switch pod lid
0helpful
1answer
0helpful
1answer

Transfer case problems

    2007 Dodge Nitro Recalls - Cars.com

    www.cars.com/recalls/dodge/nitro/2007/

    Cars.comLook up all NHTSA vehicle safety recalls for your 2007 Dodge Nitro, and contact ...THE TRANSFER CASE HEAT SHIELD MAY DROP DOWN AND RUB ON THE ...ADDITIONALLY, THE DRIVE SHAFT FAILURE WILL RESULT IN A LOSS OF ...

    Differential and Transfer Case ' Dodge Nitro Forum

    www.nitroforumz.com > ... > Detailing and General Maintenance Forum
    Jul 24, 2010 - Vehicle: 2007 Nitro 4X4. Trim: SLT. Color: Black. Found this while searching for instructions on Front/Rear Axle and Transfer case fluid changes ... transfer case leak
    Aug 21, 2014
    Front Axle CV Joint
    Nov 24, 2013
    Leaky Transfer Case
    Oct 4, 2011
    More results from www.nitroforumz.com images for 2007 Dodge Nitro Transfer case problems
0helpful
1answer

HOW DO I REPLACE AC CONDENSER ON 2007 DODGE NITRO

well your gonna need a few special tools for this , im not sure your avg home mech would want to spend the money to buy them, (vac pump , charging hoses, referigerant, o-ring seal release tools) and etc. and thats just the itmes you need to make it work again, your gonna need the new condenser and some long-g-g socket extensions to reach the old one for removal
0helpful
1answer

What is the diagrahm for serpentine belt of 2007 dodge nitro without A.C. compressor

go to gates web suite or the dayo belt web suite one of them has a picture for it
0helpful
1answer

2007 dodge nitro AC will only work after engine heats up

clutch problem in the ac compressor pulley have it checked
0helpful
1answer

2007 Dodge Nitro AC and Heat stopped blowing

if the motor worked intermittently this sounds like the blower motor is bad and needs replacing.
1helpful
1answer

2007 dodge nitro not blowing cold air

The AC compressor may need recharged, or repaired / replaced. A lot of times what happens is through the winter AC units aren't ran so the seals recieve no oil and dry out letting coolant escape. Sometimes you can get lucky and a recharge (which contains oil essential for your seals) will do it - if they are too dry however, you will need a new compressor. You can have your AC unit recharged at nearly any dealership except in the state of California. Hope this helps.
Not finding what you are looking for?

1,068 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...