Does the engine have crankshaft & camshaft position sensors if it has a distributor?
Yes it can. distributor is ignition. crank sensor generates injector pulse as a rule, fuel system, cam and crank codes together on an OHC (over,head,cam) engine? timming chain or belt issue
SOURCE: dodge caravan 1997 3.3l Xavierfrancofuenmayor
Had similar problems occur on various Chrysler products manufactured since 1986. What I did was remove the computer from the car and then take a Dremel tool with wire brush attachment and lightly buff all the pins of the computer--tops, sides and backs. After this I then take a jewelers round file and insert the tip into each connector pin hole and very lightly file it to remove any corrision. When I reassembling the connector plug to the computer I placed a good size dab of silicon grease on the plug in the center (acts as a seal when seated). This has eliminated the problem on four different vehicles.
SOURCE: 1997 hombre 2.2 liter misfiring, and loses power:
it sounds like you need to re time the motor .the belt must of sliped.
SOURCE: code reads P0340 Camshaft position Sensor circuit
That makes the computor think the timing is off. Replace the sensor and see if that does it. You will then have to have the code cleared (erased) or the light will come back on/stay on.
SOURCE: 2000 dodge caravan 3.0 has code# po1391 . replaced
po 1391 is crankshaft sensor or cam sensor change crankshaft sensor
SOURCE: replace crankshaft position sensor in 2003 dodge caravan 3.3 V6
According to Haynes, the V6 engine has the sensor mounted in the bellhousing on the back of the engine.
Crankshaft -camshaft timing misalignment bank 1 sensor 1
- The pcm detects that the camshaft position is out of phase with the crankshaft position
Probable Cause[s]
391 views
Usually answered in minutes!
×