Base timing position for the crank and cam on a Nissan is when the keyway on the cam gear is facing up and the keyway on crank gear is facing up.Must have disturbed the engine when removing the harmonic balancer?
The KA24E must have both facing up with the cylinder #1 at top dead center on the compression stroke. I can only assume that the crank spun while trying to get the harmonic balancer off. Otherwise is the mark on the crank pointed down ( cyl #1 off of tdv)?
Same happened to me. Economic way to ensure its at tdc is to remove #1 plug, using a thin dowel rod mark the distance it travels inside spark plug hole. Turn crankshaft slightly until you can measure the #1 piston is at its highest position. You'll be at tdc.
SOURCE: CRANK SHAFT POSITION SENSOR 20002 NISSAN ALTIMA
1st, Nissan had a recall on Crank position sensors for 2002-2006 Altima's. Check with you dealer before you go doing any repairs. You may discover you can get your car repaired at no charge.
NHTSA Campaign ID number :O7V527000
Symptom: Erratic behavior. Stalling and no starts and very difficult to diagnose due to the time frame in which the component actually malfunctions. The warranty should not be limited to the original owner.
I would also need more specifics as to which engine you have so I might assist you in where the location of the sensor is. The Altima had a 4 and a 6 cyl engine offered that year.
SOURCE: 1995 nissan pickup 4 cylinder timing chain - 256k miles
did u recently buy it used-mite of been already done--how r the other components enginewise-its an old car n theyll be more things--but if u luv it then get a haynes repair manual at the zone
SOURCE: 1995 nissan pickup throttle position sensor
ok on a 2.4l on the black/green and white wires use ohm meter and there is no specific spec for that engine just make sure the the resistance changes and there is no dead spots. for the 3.0l black and white wires specs are 1.0-9.0k ohms im guessing the specs are the same either engine. close to full open
SOURCE: For the 1994 Nissan Pickup 2.4 l engine, does it
The 2.4 liter engine has a timing chain.
Testimonial: "Thank you very much! I consider myself very fortunate to have 300,000+ miles on the truck without changing the chain!"
SOURCE: I have a1997 nissan 4x4 pickup with a ka24e bad
Its so rare, check this firing order for 1997 Nissan D21 Hardbody SE King Cab 2WD 2.4 liter DOHC L4 (KA24E) and 1995 Nissan D21 Hardbody 2WD 2.4 liter DOHC L4 (KA24E)...
Fig. 2: KA24E Engine Engine firing order: 1-3-4-2 / Distributor rotation: counterclockwise
Hope helps.
549 views
Usually answered in minutes!
×