Engine trouble code P1295 - 2007 Hyundai Entourage Limited Minivan

Hyundai released a technical information bulletin regarding P2106 and that should be addressed first, if you can find it.

When the check engine light is switched on it means the closed loop system is switched off and the engine is running on the get-you-home programme.

The codes you are reading are manufacturer specific and better results are usually obtained using dealer level diagnostic equipment.

Sometimes the codes don't clear themselves after a repair. If the codes aren't erased the brain assumes the faults still exist. Throwing a new part at a problem before knowing the part is faulty is expensive, especially when the code could be caused by poor connections or wiring problems.

no engine stated.
answering for usa rodeo. only. on a usa forum.
it means trouble; the factory manual covers this.
As does mitchells DIY online, read that much>?
those are called DTCs , scan codes. diagnostic trouble codes.
The PCM looks for problems all the time running,
CALLED MONITORS (a sort of nanny)
all cars do this 96 to now, in USA. by law.
If no book or no mitchells try google (or the like)
if you had you'd have seen isuzu examples.

but google finds this in 1 click.

the great justanswersl.com (ASE Techs)?
1125
1295
1515
DTC P1125: ELECTRIC THROTTLE CONTROL (ETC) LIMIT PERFORMANCE MODE.
2nd hit.,
P1125 Isuzu Electronic Throttle Control Limit Performance Mode P1221 Isuzu Throttle Position Sensor 1-2 Circuit Performance P1295 Isuzu Electronic Throttle Control Power Management Mode P1515 Isuzu TP Sensor To MAF Sensor Correlation


the first hit said, bad grounds top engine to PCM
and bad harness wires to above same place.
but as all techs, no, bad wires, happen all the time.
as do vast other reasons.
what I do , as the FSM states, clearly
is pick one failure and correct it, and sometimes gets them all.
like blown fuses do, on all vehicles.

1125 means limphome, is in force Low power too.
the TPS is acting up.
the 1515 means in English
that the Throttle angle and air flow dO NOT JIBE.
my jeep books calls that "incongruity": (nicer word)
or they differ. and should not.
i'd be checking the TPS voltages. for correct voltage.
this can fail for wires, rust, and bad sensors.
the word performance means it reads funny. (wrong)


we use a real scan tool and a real volt meter to see what the readings are on these parts.
why not get a real ASE tech to find it.
they know all that electronics magic,
ALL learn that there can be false codes.
one failure can trip many codes, but only one is the fundamental code.

or vacuum leaks cause many errors but not one
states vacuum leaks.
see?

Go to Google & type: Ford OBD P1295

Tracie

Just Google them. It is all online

Make model (code number)

https://www.google.com/search?q=Holdern+frontera++C1341

C1341 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction. Fuel Rail Pressure Sensor Circuit Malfunction and Engine Shutoff Solenoid ...

..

P2106 is throttle actuator control system-forced limited power
P2135 is throttle / padel position sensor A/B voltage correction

as for the last code well i have never seen it

is a honda code and i dont remember what it was .

P1125 is: Throttle Positioning Sensor intermittent.
P1295 is: Multiple faults on bank 1 (right)
P1550 is: Power steering pressure sensor out of self test range.
Well the ECM recognizes 3 codes. Were these codes stored as inactive (in the history section)? Or are these codes all active? Code P1125 and P1295 may be related but P1550 is separate. How else may I help?

Code P1295,P2106 are malfunction in electronic throttle control. P2135 is a fault in throttle pedal position.It might have a crack in the intake manifold. Check with dealer for possible warranty.

You need to replace your electronic throttle body, very common problem in Hyundais.

1295 = Electronic Throttle Control
2106 = Engine is in "Limp Home" Mod