2007 ford explorer power running board want retract.

Question edited for clarity and spelling of 'console'.
Question moved to model category.

They are called blend door actuators. You just check them all for operation. You have one that has failed or become unclipped. Details in the link

https://www.google.com/search?q=2007+Ford+Explorer+Sport+Trac+blend+door+actuator+diagram

..

Sounds like a wheel bearing is going out. Put your Explorer on a floor jack and raise the left front tire off the ground. Grab ahold of the tire and see if you can make it move any by pushing/pulling on the top side or bottom. Any play (movement) in the tire/wheel indicates a bearing might be out or on its way out. Is it a 4x4 or a 2X4?

Have you checked the bulbs? There are individual fuses for each headlamp so you'll want to check those also. they are in the battery junction box which is under the hood on the driver's side, fuse 29 is for the right headlamp and fuse 34 is for the left headlamp.

Other then going to a dealer, I would google " Ford running boards are not in Sync" and see if you can find out how to fix it thru a forum Q&A

It's behind a pop out panel. Look below the instrument panel on the drivers' side (just to the left of the steering wheel) on the bottom of the assembly.

under the dash or on the side of the dash with door opened.
or side of kick panel.

keep me posted
thank you
jm

throttle position sensor

If the running boards are out before start your vehicle, open door,go to your fuse box and pull the fuse. The back of the panel will tell you what each fuse is for and location. This'll keep them from retracting.

On your 99 model the module is located behind the left quarter trim panel,mid-way.You maybe able to see it by removing the speaker cover or the cupholder on top. The module will have a sticker with a 5 digit code.
On the 04 the model is behind the right quarter trim panel toward the front about even with the right rear door stricker.

will have to take the side panel off where the belt is located make sure no twists are present. if not pull it hard and see if it retracts, if it still does not retract you may have to replace the unit.
the retraction spring in the unit is broken, or the lock mechanism has failed.