Nothing yet, just started leaking.
Yes, this is a pretty easy fix. You can replace the fitting but I would buy the replacement line and put that in. the fittings will already be on it and bent to fit. If you are leaking at the fitting there are probably several other points along the line that are ready to pop.
Testimonial: "The coolant is leaking on the fitting that is in the radiator, is that replaceable also."
If you take the radiator out and take that to a welder he can fix it for you. If he is your buddy it will be about 20 bucks. If not then it is cheaper to buy a new radiator and put it in.
×
"The coolant is leaking on the fitting that is in the radiator, is that replaceable also."
No...it could be repaired, but they are usually soldered together. If the line is threaded in, you could use a solvent resistant pipe thread compound and it may work.
Remove the pressure cap. Place it aside for the new radiator.
Drain the coolant into a drain pan. The drain valve is located at the bottom of the radiator. Twist it counterclockwise until the fluid starts to drain. Close the valve when the coolant stops draining.
Locate the transmission lines at the bottom of the radiator. Ensure you mark both of the lines so you will know which one goes where. Unscrew these with a line wrench. Plug the line with a towel to prevent the transmission fluid from leaking out.
Unscrew the radiator hoses at the top and bottom of the radiator. The hoses are held on by hose clamps that can be loosened with a flat head screwdriver. Slide the hoses off the radiator with your fingers after the hose clamp is loosened.
Pry the overflow hose off with your fingers. The hose slides over a tube at the neck of the radiator.
Unscrew the mounting bolts at the base of the radiator. There will be one bolt on each side which can be unbolted with a socket wrench.
Unsnap any sensors connected to the radiator. They will have quick connect fittings that can be undone by separating the tabs and pulling apart.
Unscrew the fan shroud with a socket wrench. The fan shroud will slide off the top of the radiator. You can also remove the cooling fan as it is held onto the fan clutch by four small bolts. You will need a socket wrench to remove.
Lift the radiator out from the hood. You may need assistance as the radiator can be heavy and awkward to lift.
996 views
Usually answered in minutes!
×