Replaced washer pump and still no pressure

Get someone to use the washer jet while you listen by the washer bottle. If you can't hear the noise of the pump working, it has more than likely failed. There is a possibility the washer switch has failed. A test light on the washer pump plug will tell if the washer pump circuit is working. Hook up the light and press the washer pump switch and it should light up. If both the washer pump and switch appear to be working, the jets are clogged and/or you have a split line (obvious due to water leaking from somewhere) A tip - don't use additives and use rain or distilled water. Detergents can attack rubber seals and tap water can cause scale to build up (plus it will leave water spots)

clogged lines frozen or debris --hole in line --no fluid --damaged tank--motor /pump damaged or faulty--wiring problem

A washer pump in a car's windshield wiping system moves washer fluid from a reservoir through hoses. The motorized pump pressurizes the fluid to allow it to be squirted from the hoses through nozzles onto the front and/or rear windshield of a car. The washer fluid helps windshield wipers get rid of rain, dirt, or other objects that can interfere with a driver's visibility. If your washer fluid is not being sent out when activated, the solution could simply be filling the washer system's reservoir with more fluid or cleaning the nozzles and hoses. In more severe cases, the washer pump may need to be replaced. Here are steps to troubleshoot a windshield-washer pump.

Try this link in case you are stuck:

How to Troubleshoot Windshield Washer Pump

Here is another YT video for a similar purpose:

Windshield Washer Pump and System Diagnosis

it may be a pluged washer line ,try blowing it out or take a very small strand of wire and push it down the hole where it should come out while some one pushes on squirter

try and fill up the washer bottle with water for test and use it. if you hear the pump work keep using it till you see where fluid is leaking out. my guess is a hose is broken and all the fluid is leaking out

My guess is either your washer pump is bad,The washer switch in the car is bad,or there is a line or hose disconnected or loose somewhere in the assembly. The fluid will spray from two small ports beneath your windshield. Hope this helps.

first try getting to a source of compressed air,with it regulated to a low pressure so as not to blow lines off blow into the top hole on the reservoir and force fluid thru the hoses,a lot of times the hoses or sprayers on the wipers get dirt in them and cant pass the fluid,also blow back thru the sprayers to see f this helps

I expect that you have two different pumps. One for your headlights and one for the winshield. So making the following test, turn off your headlights and try to get washer in your windshield. If you hear the sound of a pump then the line is disconnected or clogged somewhere. If you don't hear anything then the pump is bad. Not hard to replace (should be attached to the reservoir), not very expensive I would say $60 in auto part store)
Hope it will help
Dan

look at waser bottle and there is a pump . replace the pump very easy to do

the windshield washer pump might be bad. It should be located somewhere on the reservoir