My outside temp & clock LEDS are blank

Need new one , when it shows dashes it's had it . Take to the dealer , they may be able to revive it with factor scan tool . An reprogramming .

IF THE CLIMATRONIC DOES NOT GET ANY TEMP OR TEMP BELOW 5 DEGREES CELCIUS IT WONT GO ON!!!THE AC IS NOT WORKING!!!THE PROBLEM U ARE HAVING SEEMS TO BE A BAD CONTACT AT EITHER THE CONNECTOR AT THE TEMP SENSOR OR AT THE CONNECTORS UNDER THE RIGHT SIDE {DRIVERS SIDE}CONNECTORS LOCATED UNDER THE PROTECTIVE CAP OF THE STEERING HYDRAULIC RESERVOIR OR THE PLENUM CHAMBER {BLACK BOX LOCATED AT THE RIGHT SIDE OF THE CAR JUST BESIDE THE SERVO}LET ME KNOW IF U HAVE ANY QUESTIONS!!

Replace the outside temp sensor. It's in front of the ac condenser.

This problem is usually the bus between the body control module and dash.If the bus wires check out o/k then you may need to replace the BCM.Check for any codes that may have been set for help in diagnostics.Let me know if you need more.MOE

i would just get a used one off ebay. usually you can find the dash with the a/c amp(pushbuttons) and the display for around 40 bucks. they are separate units(display and amp), and are mounted with screws that go into the back of the dash panel. the dash panel is easy to remove, there are 2 anchor screws on either side of the steering column. right side is under a plastic cover, the other is under the rheostat, just carefully pry them out, and you will see the screws. then the whole dash part pops out. you will need to disconnect the harness's that plug into the back of the amp, then it all comes free. it might help to put the steering wheel in the lowest position.

My audio and clock display stopped working all of a sudden. The audio system still worked fine. I had all my fuses checked previously and was told it could cost up to $800 to fix by Mazda. I pulled out fuse 31 and wiped it clean, reinserted it and now my display works as good as new. Thanks to those on this site for your help.

SMS

For general awareness, the outside air temperature sensor is located above the inside mirror.
Try to reset the temperature measurement unit: 1. Switch engine on. 2. Press and hold clock minute (min) and hour (h) buttons simultaneoutly longer than 3 seconds. The display will show new temperature measurement unit. 

Find a blank spot on the dash and make sure there is room behind it to allow a clock to fit there. Find a clock you like in a junkyard and cut a hole where you want to mount it. Careful cutting near any wiring.. Before installing, determine where power attaches to it and make a simple two wire harness ((3) if you need an extra to power a light. Use an in-line low amp fuse in both hot leads. Attach wire that runs the clock to any open acc port in the fuse block that is hot at all times. Attach light power to acc port that is only on with key. attach ground to metal frame of dash. Don't tap power from any fused circut...it may change operation of any control module in that circut. Make sure the new wires do not rest on any sharp metal under dash.
Good luck

is the digits on the dash like 1.0 or is there no digits if there is no digits you need to send your speedo dash to speedo fixer it cost me £150.00 my clock and temp digits went off and had it repaired by this company can highly recommed them

U need a new dash !!! I would recommend wrecking yard. I had the same problem on my a3 audi.

good luck