Nothing yet
Well, this good to be interesting to say the least, and probably long as well. By my gm. service information your going to need to take out the front bucket seats so the sides of the console can come off.
Remove the left front seat . Refer to Bucket Seat Replacement .
1
Front Floor Console Extension Panel
2
Retainer Clip (Qty: 5) same for right side.
Callout
Component Name
Preliminary Procedure
Remove the right front seat. Refer to Bucket Seat Replacement .
1
Front Floor Console Extension Panel
2
Retainer Clip (Qty: 5)
Front Floor Console Accessory Trim Plate Assembly
Procedure
Use a flat bladed plastic trim tool in order to release the console accessory trim plate from the console assembly.
2
Retainer Clips (Qty: 5)
Remove the front floor console accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement.
1
Front Floor Console Accessory Housing Screw (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
2 N?·m (18 lb in)
2
Front Floor Console Accessory Housing Assembly
Procedure
1
Front Floor Console Rear Trim Panel Screw (Qty: 1)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
2 N?·m (18 lb in)
2
Front Floor Console Rear Trim Panel
3
Retainer Clip (Qty: 4)
Preliminary Procedures
1
Front Floor Console Armrest Assembly Bolt (Qty: 4)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
9 N?·m (80 lb in)
2
Front Floor Console Armrest Assembly
Procedure
Position the armrest assembly out of the way leaving the electrical harness attached.
3
Front Floor Upper Console Trim Plate
Procedure
Lift the rear of the trim plate first, releasing the retainers securing the trip plate to the console assembly.
4
Retainer Clips (Qty: 4)
Front Floor Console Replacement (Enclave)
Callout
Component Name
Preliminary Procedures
1
Front Floor Console Screw (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Tighten
2 N?·m (18 lb in)
2
Front Floor Console Bolt (Qty: 10)
Tip
Before installing the right lower forward bolt, ensure that the console wiring harness is tucked below the fastener location to avoid driving the bolt into the harness.
Tighten
9 N?·m (80 lb in)
3
Front Floor Console Assembly
Procedure
Detach the clips (A, B) by pulling the center console box (C) up, and removing it from the center console (D).
Remove the screws (A, B) and clips (C), and remove the center console (D).
Install the console in the reverse order of removal, and note these items
2,212 views
Usually answered in minutes!
×