How donu bleed the fuel on a 2000 Mazda 626 lx 2.0

Under the dash beneath the steering wheel.

i need to remove the transmission

look in your owners manual

Hope his helps you.

First look at this and make sure the plug wires are connected correctly.
If the plug wires are correct then it is obvious that the cam belt was installed incorrectly of a sensor was damaged during the installation. Take it back to the person who replace the belt and nicely demand they fix it.

if u open the hood and stand on the right hand side of the car at the wheel facing the engine its on the right hand side of the gearbox under inlet manifold

yes it isn't that much if you buy them.they slide inside the coupler and release the line.

The OBD-1 two digits trouble codes listed 'code-17' as:
Oxygen sensor.

This means that the fuel and ignition systems performance are in need of attention.

1.Distributor Cap: remove the 3-bolts holding the distriboutr to its body.
2. Inspect the distributor cap for cracks, and the roror-button is not worn or broken.
3. Inspect the distributor-cap terminals are not corroded or charred. Replace if charred. Clean them out if corroded.
4. Check the distributor-rotor for cracks or corrosion on its tip, and lesser spring tension.
Replace as necessary.
5. Reverse steps 1-4 to re-install distributor cap. Be sure to remove and replace the plug wires from the old distributor-cap to the new distributor-cap one-by-one. If not, the engine would not run.

Fuel-Filter:
1. Undo the top clips holding the fuel-filter hose, and undo the lower clips also.
2. Take out the fuel-filter from its mount.
3. Replace the fuel filter as necessary.(please not the way it was mounted) Reverse removal for installation.

2.0L - 3.7 quarts.
2.5L - 4.2 quarts.

Regular is fine. I have a 626 as well with manual and it says regular.