2010 Hyundai Accent radio(96110-1E085CA). How do I find out the specs on the radio? ie watts/channel etc. Ive had to replace my speakers. Is it possible they will be a drain on the unit because they a

SOURCE: how do you remove radio from hyundai accent 1998

You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out. I'm doing this right now, actually..

SOURCE: How do you change the oil filter on a Hyundai Accent 1998/99?

Replace the oil filter after draining the old oil, and" BEFORE "adding new fresh oil, otherwise you'll be dump all that fresh oil, on the ground,while you "TRY to get the new filter installed.

Step 1 Remove drain plug,Drain oil into drain pan
Step 2 Remove oil filter
Step 3 Reinstall drain plug,qnce oil has drained.
Step 4 Fill new filter with oil,lube seal on filter.
Step 5 Install new filter, Add fresh oil to proper level.replace filler cap
Step 6 Run engine check for leaks.
Happy motoring!

SOURCE: looking for torque specs on a hyundai accent gl

1. 
   
2. For 3.0L engines, tighten head bolts in sequence to 76-83 ft. lbs. (105-115 Nm).
3. For 2.5L engines, tighten the bolts in sequence as follows:
   1. Step 1: 18 ft. lbs. (25 Nm).
   2. Step 2: Plus 60-64 degree turn.
   3. Step 3: Plus 45-49 degree turn.

Michael Thomas

• 3056 Answers
• Posted on Dec 16, 2009

SOURCE: What is the radio code for a 2002 Hyundai Accent.

Hello there:
these radios the code is installed by the dealership or the manufacture of the radio so what yo can do is to either call the dealership and give them the radios information or take the car to the dealership and they can do it there for you and somtimes it yo look at your users manual the code will be in there and it will explain the steps to program it ok
Hope this is very helpful for you.
Best regards Michael

SOURCE: need torque specs for connecting rod and main

Torque in two to three stages.
Connecting rods are 24-26 lb.ft.
Main bearing caps are 41-44 lb.ft.
Hope this helps,Chuck

Testimonial: "Thanks for the help Chuck"