Error codes po700 and po768 - 2007 Subaru B9 Tribeca

A P0768 code means that the transmission is not shifting when the computer expects it to. Possible causes could be dirty transmission fluid (fluid and filter need changing) or simply low transmission fluid.

If your fluid level is correct and if it is clean, then it's likely that there is a problem with the shifting solenoid.

However, keep this in mind. If the error code was caused by a one time problem (e.g. towing a heavy load up a high or steep hill), it's possible the system is telling you the transmission did not shift as expected. To determine if this was an intermittent problem, you can clear the code and see if it reappears. An intermittent problem will also cancel itself after a certain number of starts if the problem is not detected again.

Subaru P0700 Transmission Control System Malfunction

Subaru P0768 Shift Solenoid D Electrical

Type in odb2 po700 in google and it will pull up your answer. The other 2 codes im unformiliar with. May mean you need to update your obd2 code reader software or those are transmission codes. Go to auto zone or orielies

po700 automatic transmission control system malfunction. code po605 engine control module ROM error. code p1192 inlet air temperature circuit low.

CODE P1775 - A / T OR AUTOMATIC TRANSMISSION SWITCH LATCHED IN TCC POSITION. CODE PO732 - A / T ADDITIONAL GEAR RATIO ERROR IN SECOND GEAR. CODE PO700 - AUTOMATIC TRANSMISSION CONTROL SYSTEM MALFUNCTION CODE PO456 - EVAP SYSTEM SMALL LEAK DETECTED.POSSIBLE CAUSE FUEL TANK CAP LOOSE OR DAMAGED , SMALL LEAK PRESENT SOMEWHERE IN EVAP SYSTEM. I DID NOT SEE CODE P1788. BUT CODES P1775, P0732 , PO700 , YOU HAVE INTERNAL TRANSMISSION PROBLEMS TRANSMISSION SHOP HAS TO HOOK DIAGNOSTIC EQUIPMENT TO CHECK TRANSMISSION PRESSURE SOLENOIDS AND SHIFT SOLENOIDS. TRANSMISSION VALVE BODY HAS MANY SOLENOIDS PRESSURE SWITCH AND SENSORS COST TOO MUCH REPLACE THEM ALL LET GARAGE SCANNED TRANSMISSION BE MUCH CHEAPER.

You need to have the transmission control module scanned for codes. PO700 is just a code in the ecm to tell you that there are codes stored in the TCM.

dodges do not have a strong transmission, I would be checking salvage yards for a replacement.

the po700 code will be found in the engine controller all it means is there is a code preasent in the trans controller a good scan tool is needed to communicate with trans controller to retrieve the stored codes that specify problem

p0700 is a generic trans. code, so the problem if it is in the trans. would require further trans diag. so i would scan trans specific codes first. but in most cases when a chrysler tells you it is an internal controller fault you can believe it. just make sure which controller it is telling you has a fault!

P0700 is EATX code present. It simply means that the engine computer has noticed that the transmission computer has a dtc in it. This causes the Pcm (engine computer) to turn the check engine light on. You will need to have the TCM (trans computer) checked for codes to know what to diagnose.

error code P1776 - Replace rear solenoid switch

Likely both related The P1776 probably kicked off the P0700 notification.

Hope that helps! Happy Motoring!