Cars & Trucks Logo

Related Topics:

terry powell Posted on Dec 08, 2014

My radio is not coming on - Cars & Trucks

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
0helpful
2answers

The radio stop working, The radio intenna come up when radio is not own.

The module that controls operation cud hav issues. But its usually connectd w otherthings too. A car harness wire or bad radio also. Disconnect batt a few min and see if itclears. Or bring vehicle for a scan at autozone
0helpful
2answers

M&r electronics

there should be 2 power inputs in radio connector,1 for radio power other for memory. If you have both then radio would have to be sent out for repair.
0helpful
1answer

Radio wont come on and the fuses appear to be good

its probably the wiring behind the radio. They can come loose sometimes
0helpful
2answers

My car radio won't come on.

hi

Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black


hi please check the above mentioned wires are in place. if all in place then check weather power is coming to these lines. if power is also coming the problem lies with the system itself. please service it and it wil be ok.

if the information was usefull then vote me
1helpful
1answer

2004 Chevy Tahoe Z71 4x4 -- Radio sound comes on then goes off

Check your antenae connection on rear of radio...I know this is a pain but sometimesit comes loose.:)
0helpful
1answer

The radio won't come on

Sounds like you have a short. It will drain your battery. Pull the radio out and inspect wiring for damage and correct routing.
0helpful
1answer

Radio wont work

did you hook up the ground wire to back of radio it is not in the main plug it will go a bolt on the center of the radio and to the metal frame behind the radio
2helpful
2answers

Radio Not Working

There are 3 fuses in the interior fuse panel that feeds radio.
no. 11(10amp) is ignition switch power to the radio it comes into radio on the TN/LB wire.
no. 27 (10amp) is hot at all times and comes in on OG/LG wire.
no. 12 (5amp) is hot in run or accessory and comes in on YE/BK wire.
Check these with 12V test light at fuse and at radio connector.
30helpful
3answers

1999-2003 Ford Windstar radio removal procedure

remove the trim around the radio face be careful not to break it, it should snap off its a delicate proceedure take radio face plate off ( if equipped) radio should come out
Not finding what you are looking for?

29 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...