The lock is not properly engaging the washer that moves the switch actuating rod. Remove the cylinder and reinstall, ensuring the rod moves the switch as the lock is turned.
To install:
1. Verify the ignition switch is in the on position and the actuator rod is properly installed in the switch.
2. Rotate the cylinder clockwise to align cylinder key with the keyway in the housing.
3. Push the lock all the way in.
4. Install the screw.
5. Tighten the screw to 14 inch lbs. (1.5 Nm) for adjustable columns and 25 inch lbs. (2.8 Nm) for standard columns.
6. Re-center the SIR coil assembly.
7. Install the turn signal switch and steering wheel
8. .Connect the negative battery cable, enable the SIR system.
×