The only way I am able to get the door locks and alarm system to work again is by putting the key back into the ignition and turning it towards start and then take it out again. After I do that everything works fine.
Sounds like a programing problem. Most car accessories are controlled by a pcm or bcm (powertrain control module) or Body control module).. You call it the car computer. Sometimes a spike in voltage or some other abnormality can cause a glitch. Take it to the dealership and have them run a diagnostic and reflash the module.
SOURCE: 2001 Hyundai Elantra door locking problem
there is a short or a signal from the un-locking switch that is triggering your locks.
you have a switch manually to lock and un-lock your doors, the unlocking circuit is making contact.
you can try playing with your switch to un-short the switch or open it up ang check it.
tnx 4 using fixya,
drcool
SOURCE: I Locked my keys in my 2001 Hyundai Elantra
wellits a smilple thing they have this round wire with a handel and they will yake the strip of ur driver side window don't worry it can be put back no need to buy a new one . and he will push the wire that is connecting both the handels and then open ur door.
SOURCE: alarm problem on my 2001 elantra
This alarm system can only be 'disarmed' using the keyless remote programmed for this specific vehicle. Press the "Unlock" button on the keyless remote -- this resets/disarms the alarm system. If you do not have keyless remote for this vehicle, get one and have it programmed at a Hyundai Service Center. Problem solved.
SOURCE: The ignition to my Hyundai Tucson is in locked...
check your key see if its not damaged ok also press the break move the steering wheel slowly and move the key as you are moveing the steering wheel
SOURCE: keys lock in trunk alarm will not allow trunk switch to lock
The solution is to pull out the back seat to get into the trunk. There are two bolts holding the bottom part of back seat (bolts located between bottom and top sections). Then pull out bottom section of back seat and you see the hinge for the top section, remove the bolts and then you can lift up and access the trunk. It's not that hard.
Same thing happened with mine. It turned out that the
power door lock motor went out. Since the handle or the switch can unlock the
driver's door, both of these mechanisms are connected. When the door lock motor
goes out it freezes in whatever position, it was last engaged.
479 views
Usually answered in minutes!
×