I am trying to locate the ECM/PCM for a 2002 DODGE Stratus 3.0 Mitsubishi. This vehicle is basically an Eclipse with a Stratus Body.

under left side of dash

P0302, see I now it, but is it only 1? DTC error?
2 engines , or where? and up to 5 world wide, NO VIN
Engines, Mitsu. no clue told.


V6 2.7L? (so says dodge.com USA> go this?
2.4 L EDZ I4 4G64 I4 DOHC and SOHC
2.4 L EDV/EDT turbo I4 (Mexico)
2.7 L EER V6 ) i GUESS THIS IF Usa CAR. has 6 COPS
Coup?:
2.4 L 4G64 I4
3.0 L 6G72 V6


my best guess USA is VIN K engine, no vin told so engine is UNKNOWN,

it means, this, only.
Low combustion on #2 cylinder, (spark,fuel injection or compression bad)#2
#1 is on crank pulley end. #4 is at transmission I4, F1234R
rear means tranny end. oK?
v6
all V engines 99% #1 is the bank V that is most forward cyl. of all.
to the crank pulley's
2nd is always 2nd in firing order, always,and PCM dictates it.

2.7l v6 24v ffv . dohc mpi engine.
firing order, 2.7L 1-2-3-4-5-6 even odd ;odd banks.




causes (v6 cops)
1: spark plug bad #2
2: spark coil bad, COP 2 dead? or weak or boot bad.
3: oil flooded inside the spark plug well, shorting all above out.
4: injector bad #2 (omg PCM, nah) swap 2 top find it;
5: compression fails #2
only 1 code told so answer is 100% based on 1 code only 302
6: rare bad cam lobe.
7: rare cracks in head , antifreeze leaks to #2 combustion chamber.
8: oil leaks to #2 via all classic ways.







3.0L v6


2.7L


2.7L V6 order
1-2-3-4-5-6

Question edited for clarity and the correct name of the maker which is written on the rear of the trunk! :>D
Question moved from Heating and Cooling to the correct Vehicle category of Mitsubishi Eclipse.

Fuse 10 under the hood.

Mitsubishi Eclipse Underhood Fuse Diagram

https://blownfuse.co > mitsubishi > mitsubishi-eclipse-p...
Fuse Number Description AMP Rating 1 Fuse (+B) MAIN BATTERY FUSE 80A 2 Radiator fan motor 30A 2.4 liter, 50A 3.8 liter 3 Anti?lock braking system 60A View 23 more rows

• 
  

  Mitsubishi Eclipse Passenger Fuse Diagram

  https://blownfuse.co > mitsubishi > mitsubishi-eclipse-p...
  Feb 27, 2021 - Below is the passenger fuse diagram for the Mitsubishi Eclipse third-generation 2000, 2001, 2002, 2003, 2004, and 2005 model year.

causes include --hose leakage / blockage, basic setting not carried out ( if applicable)--wiring---EGR valve ---EGR solenoid ---ECM

have a look at this ECM PCM STARTER 2003 DODGE GRAND CARAVAN 3 3L V6 WONT START

limp mode is a system built in the ecm or pcm that will allow your vehicle to drive at a slower speed when the ecm or pcm detects a problem so that you can stop at a safe location or drive to your mechanic, when the problem is fixed the ecm or pcm will allow the vehicle to drive normal again. hope this helps,

I dont't know specifically per vehicle but most are position on the body/frame within a foot of the tank itself. Look up and image on line and then pop under your car and take a look.

A code P0500 may mean that one or more of the following has happened:
1.The Vehicle Speed Sensor (VSS) is not reading (functioning) properly 2.There is a broken/frayed wire leading to the vehicle speed sensor 3.The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
The simplest thing to do is to reset the code and see if it comes back. Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly. If the wiring and connectors are OK, then check the voltage at the speed sensor.
P1693 (M) DTC Detected in PCM/ECM or DTC
Detected in ECM
A 9Companion DTC9 was set in both the ECM and PCM which is related to the above DTC code.

Location of "ECM" is Under the Air Filter Box

1. Disconnect the negative battery cable.
2. Remove the air cleaner box, refer to the air cleaner box.
3. Remove the gray and black connector from the PCM.
   1. Remove the harness clip bracket from PCM bracket.
   2. Remove the nut from the upper bracket mount.
   3. Raise vehicle and support on hoist.
   4. Remove 2 lower bracket bolts.
      1. Remove 4 screws from bracket and remove bracket from PCM.
      INSTALLATION
      
      1. Install bracket to PCM and tighten screws.
      2. Install PCM and bracket to body and tighten the 2 lower bolts.
      3. Lower vehicle.
      4. Install upper bracket nut and tighten.
      5. Clip in wiring harness bracket.
      6. Install gray and black connectors to the PCM.
      7. Install the air cleaner box, refer to the air cleaner box.
      8. Connect the negative battery cable.

this link is to the first part of the service manual. once you download it, the information you need is on page 47 and 48.


The manual is the mitsubishi eclipse manual, but, incase you didn't know, they are basically the same car. the eclipse is just the hatchback version of the stratus.

if you look at the sticker on the firewall of the engine bay, there is a mitsubishi sticker.