2008 Volvo S40 2.4I after side accident When I switch the engine on, all information is displayed but the check engine icon remains on no codes stored. no fuel pressure. when I put brake cleaner in th

If your 2007 Volvo S80 3.2 is not starting after being involved in an accident, there could be a number of issues that need to be addressed. Here are a few things to check:

1. Ignition switch: The ignition switch is responsible for sending power to the starter motor and other electrical components. If the switch is damaged or not working properly, the engine will not start.
2. Battery: After an accident, the battery may have been damaged or disconnected. Check to make sure the battery is fully charged and connected properly.
3. Fuel system: The fuel system may have been damaged in the accident, preventing fuel from reaching the engine. Check the fuel pump, fuel filter, and fuel pressure to make sure they are working properly.
4. Starter motor: The starter motor is responsible for turning the engine over when the key is turned. If the starter motor is damaged, the engine will not start.
5. Shut-off switch: Some Volvo models have a shutoff switch that is triggered in the event of an accident to prevent the engine from starting. This switch may have been triggered and needs to be reset.
6. Key fob: The key fob needs to be in the car for the car to start. If the key fob won't come out of the ignition, it may be that the key fob is jammed inside the ignition and needs to be pulled out.

It's very likely that the shutoff switch is the cause of the problem, as you suspected. You should check your car's owner manual or contact a Volvo dealership or a professional mechanic to help you locate the shut-off switch and check if it is the cause of the problem. It's also possible that the accident caused multiple issues and it's best to have the car properly inspected by a professional.

repair abs problem have vehicle scanned for code certain codes or problems will put vehicle in limp mode for your safety and or to prevent more damage

CHECK THAT RELAY! Check the basics too, coolant level, Have scanned for codes ect.

SWITCH IGNITION ON WITH ENGINE OFF.PRESS SMALL ROUND BUTTON ON LOWER RIGHT OF THE SPEEDOMETER UNTIL IT DISPLAY ODOMETER.THEN TURN OFF IGNITION SWITCH OFF.PRESS AND HOLD SAME ROUND BUTTON LOWER RIGHT SPEEDOMETER TURN IGNITION TO ON WITH ENGINE OFF.CONTINUE TO HOLD BUTTON FOR AT LEAST 5 SECONDS UNTIL IT DISPLAY INDICATES 000000 AND MAINT REQUIRED LAMP WILL EXTINGUISH.RESETTING IS COMPLETE.

The Amber Engine Icon means the same as a Check Engine Light. Your car's ECM (Computer) has stored a Trouble Code, and you will need a OBD II Reader (On- Board Diagnostic) to get the code so you can diagnose what is wrong with your vehicle. You can go to any AutoZone and they can read the code for you at no charge. You will need to diagnose and fix the problem before the Check Engine Light will turn off.

there is a fuel shut off switch, check owners manual

look in the trunk... either it has side panels that can be removed... or you will see a hole in the side of the lining with a sticker that points out where it is.

Robert

Please take a moment to rate this solution thanks

1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.

Without multi-information display

1. Continue to press and hold the button until the trip meter displays 000000.

With multi-information display

1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.

there you go jimmy mark as fixya

Clear your engine and transmission codes, its a small box in the pass side engine compartment right behind the headlight. Search "Bay 13 Volvo" and that has all the information to check and clear the codes. It also has a list of what the codes mean to help you.