SOURCE: oil change 2007 chevy malibu maxx
2.2L takes 5 quarts
3.5L and 3.9L take 4 quarts
Both quantities are with oil and filter change
SOURCE: 1999 chevy malibu
That engine does not have a timing belt, it has a timing chain and therefore much easier to work with as it can only go on a certain way, the primary focus being getting the dots on the timing chain sprockets lined up properly.
I believe, with the engine at Top Dead Center on cylinder #1, the dots will be facing each other. That is to say, the do on the cam sprocket will be facing the dot on the crank sprocket.
SOURCE: NEED 2007 CHEVY MALIBU RADIO CODE
I just got the code for my radio by calling 1-800-537-5140 and choosing the option for my vehicle make. 1 for chevrolet. then i entered 106010 for the customer # and then entered my serial # from the stereo and it gave me a lock code for free. Now i am just trying to figure out how to enter it since my manual tells me to take it to the dealership. Now that you have your 4 to 6 digit code, you can enter it by following the these steps. 1. Make sure your ignition is in the "on" position, but no started. 2. Press/Hold the "HR" button to set the first 2 or 3 numbers. 3. Press/Hold the "Min" button to set the next 2/3 numbers. 4. Press the AM/FM button one time. "SEC" should be displayed. You can now turn the radio on. Good luck!
SOURCE: dtc code p0121 and p2135 2007 chevy malibu
both codes refer to the throttle position sensor, the sensor is at the throttle plate, on the side of the throttle body. to test remove the connector to sensor, use a ohms meter to test. put 1 lead to top connection and the other to the bottom one. move throttle and the needles on the ohms meter should move very even, move throttle slow to get a good reading, needle should move without no hesitation, if the test is bad replace tps sensor. if the sensor gets to bad, it can have an effect on transmission shifting. after fixing sensor have the light turned of with an obd2 scanner.
124 views
Usually answered in minutes!
×