Sorry! How do I remove a unscrews starter from a 95 chevy blazer?

Disconnect battery first
lift up the truck
Drain transmission liquid
use transmission lifter to raise and lower transmission
unscrew bolts connecting transmission to engine
unscrew bolts connecting transmission to the back of your truck
unscrew bolts connecting transmission to the frame
will come freely. Be careful

If you have the spider fuel system, I'd check that first. That system is noted for problems. Key on engine off fuel pressure-- 60--66psi ,
Also, the fuel poppet valves can stick.

Fix your car right away by clicking the link I attached
Chevy Blazer 1995 2005 Factory Service Workshop repair manual

place the front of the car on jack stands than take off the front passenger side wheel and remove the starter from the inner wheel well

Hi natgonzo, your Blazer doesn't use a starter relay, it only has a starter solenoid which is attached to the top of the starter motor. Hope this helps.

Please rate my advise.

You'll want to remove the radiator cap. On that tank, on the bottom toward the engine is a drain to unscrew. You might want to spray some WD-40 on the drain plug, to help get it unscrewed.

On 95-97 and 1998, both the turn signal and hazard flashers are located behind the lower dashboard trim just to the left of the cigarette lighter. You can not get to it without taking apart the trim (stupid design). Or you have to drill a 2" diameter hole in the trim with a velcro cover so you would never have to do it again1999 and later it is under the glove compartment
to disassemble it without drilling
It's behind the panel to the left of the cigarrette lighter. You need a Torx 25 screwdriver and another screwdriver for those hex shaped screws, forgot the size. First unscrew the 2 Torx 25 screws beneath the steering wheel. Then unscrew the rest of those Hex screws on the bottom. The panels overlap, so be prepared for a lot of unscrewing. You do need to unscrew the middle black panel on the bottom, right beneath the cig lighter. It's held by two Hex shaped screws, one on each side and are hard to unscrew. Also you need to remove your spare change sliding tray to unscrew the last hex looking screw. Once you pop your panel off, the turn signal flasher is the right one. The Hazard flasher is the left one. You can find a replacement part at Autozone, and DON'T get the $184 Flasher switch, all you need is the signal flasher. It's shaped like a cylinder with TWO prongs on it.

NO, it's kind of tight, but it's not that bad. You do need to remove the torque converter cover, and slide/rotate it as much to the driver's side of the vehicle as possible.

95-94-93 4.3 vortec are compatable engines. 97 4.3 will fit but will have problems with sensors and computer

Here's the complete chart of trouble codes for your Blazer...including the ones that you asked for. Hope it helps! Have a great day!