Where is the map sensor located on my ford mondeo mk111 di estate and is there a photo of it
SOURCE: how to change headlight bulb on ford mondeo
Very easy, 2 or 3 minutes.
Remove radiator grille. 2 plastic fittings on top, quarter turn and lift out grille.
Remove complete headlight. Simply lift out 2 L shape retaining pins. Disconnect lead. Ease out complete headlamp unit.
Remove back of headlamp unit to access bulbs. Disconnect lead from bulb while bulb still held by clip. Then release clip to remove bulb.
Reverse process to fit.
SOURCE: Ford Mondeo Mk3 Estate 2L. Air bag / seat belt Warning Light
Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.
Just push it together properly and it should clear the AirBag fault
SOURCE: ford mondeo 2001 has misfire and wont tick over
Any engine will have trouble ticking over if only 3 of the 4 cylinders are working. Check the spark plug for a consistent spark on all cylinders. Check the connections to the fuel injectors on the cylinder head, and check the compression in all cylinders (take spark plugs out and use a compression tester whilst turning the engine over on the key). Low compression in one cylinder may mean head gasket failure, valves out of adjustment (staying open) or bigtime piston or piston-rings failure.
Testimonial: "thanks"
SOURCE: location of the bank 1 sensor 2 O2 sensor on a 2001 ford escape
B1 means the sensor is located on the same bank of the engine that has the #1 cylinder. B2 is located on the opposite bank.
S1 means the sensor is located BEFORE the catalytic converter
S2 means the sensor is located AFTER the catalytic converter
You didn't say which engine you have, so I've included the diagrams of both 4 cyl and 6 cyl so you can see the banks
632 views
Usually answered in minutes!
×