Trying to see if fuel pump is issue with my 1998 range rover
What you are describing is an indication of no fuel getting into the engine. You need to check the fuel pump with a pressure gauge if you have one. This could be the fuel filter that is clogged too. The pump is electric and it is in the fuel tank. Check the fuse to make sure that it is ok. Changing them out is not easy if the fuel tank is full and it is dangerous in any condition because of the flammable nature of gasoline.
SOURCE: 1998 land rover discovery won't start
I just expiriance the same problems on my rover so i check it out and found that the engine spark fuse was out. I replaced the said fuse and their you go it started. You can find that fuse under the dashboard in the satellite 1 fuse box. it should be the 3rd one from the right. Good luck buddy hope that helps you out.
SOURCE: Range Rover p38 bmw 2.5 injection running problem
Hello,
It turned out to be a broken wire on the injector which was causing a bad connection,now running better than before.
The cold was just a coincidence.
Thank you and best regards,Yvonne
SOURCE: my 197 range rover wont start -replaced fuse box
hi i have a range rover p38 2.5 diesel it starts but wont drive when you put in drive
SOURCE: range rover l322 2002 heavy power steering renewed
The Solenoid fitted on the Steering Rack is not getting the command from The Body Control Unit. Kindly Replace your BCM and then your problem is solved. You can try to make sure by giving direct current of 12v to the solenoid and check the Steering. if it works then simply change the BCM as it's not giving d command to the Solenoid. Salman EiD
SOURCE: 1999 range rover se changed fuel pump, truck still
why you have replaced the Fuel pump? who advised you to do so?
be guided as follow
1. on the Engine Side on the top there is a fuel rail for the injectors. turn the ign. key to the second position (on) and check the valve located on the fuel rail if fuel is coming pressurized and still won't work. then open on of the spark plugs wires and check if spark is there. (Be Careful doing that). if no spark then is there any message comes up on the Dash? if not messages then you can check the Crank Sensor if no current being generated from the ign. coils.
300 views
Usually answered in minutes!
×