My 2004 Town and country van had to be jump started and now key fob won't lock or unlock doors.Took key fob to locksmith he said key fob was working, van was not reading signal and he didn't know what was wrong.Help please if you can.
The fob may need to be reprommed to the car. Do the following:
Grab your working remote. Push the LOCK button five times, allowing exactly two seconds to pass between each press of the LOCK button. Insert the ignition key and turn it to RUN. Push and hold UNLOCK on the working remote for 6 seconds. Push and hold PANIC for one second while continuing to hold UNLOCK. Release both buttons at the same time.
Push any button on the remote to program it. Then push any button on the remote that was already programmed. It has to be reprogrammed. The remote is now programmed to the vehicle. Turn the key to OFF.
SOURCE: 2000 town and country van back door will not unlock
sounds like the lock is seized, you will have to remove the panel,it's held on with screws and snap plugs, remove all the screws and then gently pull the panel off. you will be able to open the hatch by sliding the lever sideways. the latch and mechanical lock are the same unit. it has a electrical actuator. your dealer or regular tech sould be of great help in this very simple matter.
SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock
For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.
SOURCE: key fob does not unlock the doors
remove the keyring from the fob open it and replace the watch battery in it
SOURCE: while drivingthe door locks sometimes start unlocking and locking
You have a bare wire that is rubbing. Take to your local dealership.
SOURCE: 2005 chrysler town and country
Welcome to FIxYa.com have you disconnected power to battery or did the battery go dead on you? size of your engine please? Thank you for using FixYa.com Regards, Lee Davidian
419 views
Usually answered in minutes!
×