SOURCE: mazda tribute abs fault. abs
These vehicles have a recall on the ABS system for faulty wiring. You may want to check with your local dealer to see if your vehicle is included.
SOURCE: ABS Light illuminated on Van
ABS diagnostics requires a scan tool (Chrysler DRB II, DRB III or aftermarket equivalent). the plug is located near the brake pedal. this is the only alternative to get the ABS light off.
SOURCE: 2001 chevy s10 blazer abs light stays .
The abs is a add on for the brakes that when the tires come into a skid or slid they wont lock up..Your brakes will still work great with the abs disabled but your brakes will lock up if you push on the brakes hard enough to stop.Mainly abs works in slippery conditions not letting the tires lock up and keep the car rolling instead of making it slide..But no effect of the brakes will happen..Just make sure your fluid is full and there are no leaks and if you want to get them check you can stop by your local Auto Zone and they will scan your car for free and tell you what sensor is bad..I hope this was helpful to you...Have a great night
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: 2001 ford taurus ABS will not light but brake light on
You have a bad ABS module. Had the same problem with my 2000 Taurus. The ABS module is a Bosch 5.3 You can have yours rebuilt for $170 or go to a junk yard and pull one from a 2000-2003 Taurus. Make sure its a traction control module if you have it on your car!
SOURCE: 2005 mazda tribute....abs problem
a speed sensor on the front,have the ABS system scaned for the codes(this will show you wich sensor is bad)
180 views
Usually answered in minutes!
×