SOURCE: 1987 Chevy G20 van replace power steering pump
Does your van have the serpentine belt? If so maybe I can help, I replaced the Power steering pump on my 90 G20 a couple of weeks ago. The trick is that you need to pull the pump pulley which is pressed on to access the mounting bolts which attach the pump to the engine. Harbor Freight tools sells a great tool designed for this job for $20.00. Once you have the correct tools, remove the serpentine drive belt. You may also need to remove the fan shroud. the pump shaft looks like it has an allen socket in the center, but this is for use in the manufacturing process, and will not come out. Place the puller tool on the pulley following tthe instruction that come with the tool, and remove the pulley. loosen, but do not remove the nut on the high pressure hose connection. use a pair of **** pliers to cut and remove the crimp clamp on the low pressure hose. If your pump has the remote reservour loosen the clamp on the reservour hose also. Remove the three mounting bolts, place a large pan under the pump to catch drips, and remove the prevously loosened hoses. there will be fluid leaking all over and the pump should come free, There are two types of replacement pump sold. With and without reservour. This reservour is a metal cover that fits over the back of the pump, and should not be confused with the reomte revervour found on some newer models which is next to the battery. This reservour is held in place be two throught the pump bolts which are removed at the back of the pump. If your new pump has a reservour you will probably still need to remove these bolts and put them in the replacement pump as most are shiped without these bolts. If you replacement pump comes without a reservour pull the bolts, the reservour should pull off of the old pump and slide onto the new one. check the o rings and replace the through the pump bolts. Installation is the reverse of removal execpt that 1/2" hose clamps replace the crimp clamps on the low pressure hose, and the puller tool is set up differently to replace the pulley. Finally if you don't flush contaminants out of the system your repair will last maybe a week. www.cardone.com has a great article about power steering flushing, read it before you start Good luck.
SOURCE: Electronic Control Module Installation 1994 G20 Chevy Van
I just had the same problem. If it is a regular van try under the driver seat in a plastic box. If it is a conversion van try in a pannel just behind driver seat on side of van wall behind a pannel that looks like a vent.
SOURCE: fuel pump relay for a 1994 Chevy Truck WT1500
The Fuel Pump Relay is located in the Glove Box under a little cover on the upper left side. The Fuel Control Relay is the left relay and The Fuel Pump Relay is the right. To test these relays, swap them and then try to start the vehicle, or blow the horn. If the horn blows then use that relay for the pump and you may at least drive the vehicle where needed! If the vehicle starts, then replace them as a pair.
SOURCE: 93 Pont Gran Am fuel pump relay location
under the hood in a black box though its not labled it is 2"x2" there should be one for the power windows rite nxt to it and yes they are the same so you can switch them...
SOURCE: My 93 chevy g20 van heater doesn't work very well.
you want to get a thermostat that has a low temp release. when u have a hightemp release it does not open til it reaches a hot temp. when you put the low temp in it releases earlier and warms the heater core up as the engine warms up.
9,962 views
Usually answered in minutes!
×