Where is the Camshaft Position sensor located on a 2000 Hyundai Sonata V6

Videos here

https://www.google.com/search?q=crankshaft+position+sensor+located+on+my+2001+Hyundai+Sonata+V6

Picture here

https://www.google.com/url?sa=i&url=https%3A%2F%2Fellagracebranch.blogspot.com%2F2020%2F07%2Fcrankshaft-position-sensor-2004-hyundai.html&psig=AOvVaw3aJBa_W6lB4gUvlvrvROeD&ust=1614879069025000&source=images&cd=vfe&ved=0CAIQjRxqFwoTCMDS3rvTlO8CFQAAAAAdAAAAABAD

..

Watch the video of the replacement job 2004 Hyundai Sonata Optima V6 2 7 crankshaft position sensor location and...

Look at 2000 hyundai accent camshaft position sensor location Google Search

follow this link for a u-tube video , it is a lot of work and there must be an easier way but i've not found it yet
Crank sensor 2000 Sonata

My online Sonata manual shows these possibilities, but does not identify which applies specifically to 2000 Sonata.
Also, when you talk to the dealership parts counter, you'll need to know whether your 2000 Sonata is (a) 4-cylinder 2.4L MFI DOHC engine, or (b) 6-cylinder 2.5L MFI DOHC engine.
Its easy to tell - just count your spark plug wires.

-- begine excerpt from 2000 Hyundai Sonata Repair guide --

The crankshaft position sensor is located next to the flywheel.
The crankshaft position sensor is located next to the flywheel/torque converter.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The crankshaft position sensor is located on the driver-s side of the vehicle, down by the lower radiator hose.
The crankshaft position sensor is located on the engine near the crankshaft pulley.
The crankshaft position sensor is located at the front of the engine near the timing belt.

--- end excerpt from 2000 Hyundai Sonata repai guide ---

hi,
i have attached the image, showing the position of crankshaft position sensor.hope its helpful for you. Please rate my solution as helpful.have a great day.

The sensor is located on the left hand rear side of the block (near the bell housing). It is held in place by a 10mm bolt. It's to the right of the exhaust manifold (LH - radiator side) on the V6. Once you purchase the new sensor you'll be able to identify it on the engine. The connector to this sensor is located in the illustration.
A word to the wise... replace the O2 snsr as well.

camshaft position sensor and one crankshaft position sensor

Firstly, what's a TDC sensor?.. the crank position sensor? If so, on the four (4) cylinder, it's located behind the timing belt cover at the crankshaft.. if it's the 2.5 V6, it's located behind the LH exhaust manifold on the engine block.