2012 Chevrolet Equinox LS 4dr SUV 2.4L 4-cyl. FFV 6-speed Automatic Logo
A
Anonymous Posted on Oct 20, 2014

<!-- from fixya rte -->Misfire cylinder 5 chevy equinox 2005 - 2012 Chevrolet Equinox LS 4dr SUV 2.4L 4-cyl. FFV 6-speed Automatic

1 Answer

carlos falero

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

  • Chevrolet Master 1,327 Answers
  • Posted on Oct 21, 2014
 carlos falero
Chevrolet Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

Joined: Apr 16, 2009
Answers
1327
Questions
2
Helped
348831
Points
2968

You say your engine is a 2.4 only have 4 cylinders

5 Related Answers

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Dec 12, 2009

SOURCE: randome misfire on all cylinders only under load

Try putting in bosch spark plugs with the 3 electrodes ,might help .As for the code reading well i wouldnt trust that because as its a new car then the chances are its encrypted software so the code you have will not be right.If the plugs do not cure it then its dealer only and i wouldnt be surprised if it didnt end up with a new ECU unit

Ad

Anonymous

  • 1033 Answers
  • Posted on Feb 26, 2010

SOURCE: install catalytic converter on 2005 chevy equinox

A muffler shop can install this, it needs to be welded on. Unless you have the equipment. The old has to be cut off and new installed.

Anonymous

  • 2 Answers
  • Posted on Mar 28, 2010

SOURCE: 2005 chevy equinox rear hatch not locking

I've had the exact opposite issue with my 2005 Equinox.
My rear door is locked and will not unlock.

Anonymous

  • 184 Answers
  • Posted on Mar 30, 2010

SOURCE: Where is the transmission Fill plug on a 2005 chevy equinox?

There is no fill plug on transmission pans, you have to fill them from the
dipstick tube in the engine bay. Get a long funnel that will fit into the
dipstick tube hole, and then fill it that way. Make sure you turn the
vehicle on while filling it, and put it through all the gears, with your foot
on the brake. This will make sure your torque convertor is being properly
filled, along with the trans. Good luck.

Anonymous

  • 4793 Answers
  • Posted on Jul 09, 2010

SOURCE: 2005 Chevy Equinox, LT

at 60k, if it aint been done,do the lot.....filters oils.....antifreeze.....belts.....timing belt. then you have another 60k before you have another big bill.....

Testimonial: "Thanks for the help. I didn't realize that it would need a timing belt so soon."

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 2005 chevy equinox misfire on cylinder 5, how can I fix it

posible spark plug but also can be you coil pack for that cylinder the module or the spark wire
0helpful
1answer

2005 chevy equinox what are problem codes po405

405 is EGR sensor circuit a low. 300 is random misfire. An open EGR can cause random misfires.

0helpful
1answer

2005 Chevrolet equinox misfire code p0301

p0301 is a misfire in cylinder # 1 replace that coil pack ,regaping plugs won't cure it
1helpful
1answer

Cylinder 2 misfire 2005 chevy equinox

this could be a bad plug,wire/coil over plug,fuel injector or dirty one,or a cylinder problem such as carbon build up on the back of the valves,or a compression problem.start by checking out the plug then the wire,if you have it put on a scan tool it may show whether its an electrical problem for the cylinder of possibly a fuel problem.
0helpful
1answer

Have a DTC po305 (misfire #5 CYLINDER) on 2006 chevy equinox, So far I have replaced the coil pack, spark plug, plug wire and injector. Still have the p0305.No apparent vacum leaks. Checked injector pulse...

On the 3.4 engine used in the equinox the crossover pipe from the front manifold dumps in at the corner of #5 cylinder, therefore this area in subject to more heat than any other cylinder. #5 is very commonly known for burnt exhuast valves because of this, usually only noticable at idle and smoothed out around 1000-1200 rpm
1helpful
1answer

My 2005 Chevy Equinox LT has a number 1 cylinder misfire. I already had the spark plugs and wires changed. I also had the coil changed and it still misfires. I checked it with my OB2 computer, and it reads...

Have you done a compression check? I had the same problem on an S-10 Chevy pick up. Found that # 3 cylinder had low compression due to a burnt exhaust valve. No more problems after having valve job done on the engine.
3helpful
2answers

2005 Chevy Equinox Transmission problems, need help.

I currently have P0742 and P0700 problem on my 2005 Chevy Equinox. My car engine flares often and sometimes the gears don't shift. Do you have any tips on how you fixed these problems?
1helpful
1answer

I have a 2005 chevy equinox and the key will not turn.The steering wheel is not locking either. Any ideas?

Common problem with the lock cylinder on the Equinox and other GM producst such at the Grand Am. Need the cylinder replaced.
1helpful
3answers

2005 Chevy Equinox the key will not turn past the ACC position so it can not be started. Also, when unlock button hit on remote dash lights flash.

Equinox/Torrent body vehicles have a common ign cylinder problem. The repair is supposed to be to remove the cylinder , clean and coat end with PTE grease. This seldom works. The best way to fix a non turning cylinder is to replace it.
Not finding what you are looking for?

919 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...