How do I erase the ABS and VSC codes in my 2007 Prius

Hello, it's not a fuse problem, there is a fault code in the ABS computer that should be diagnosed using a code reader that can access the abs/vsc system.

VSC ABS and ! lights plus red (!) - Toyota Prius Forum ...

www.priusonline.com/...toyota-prius.../19804-vsc-abs-lights-plus-red.ht...

Jun 3, 2008 - 8 posts - ‎3 authors
If the accumulator fails, you will get a red brake warning light and the pump will now run continuosly until it burns out. ... hydraulic pressure to the brake system and "no"red warning lights. .... Fog Lights, PassGas, Toyota Prius General Discussion, 4, 10-13-2005 09:12 AM ... 11-13-2015 10:01 PM by Tim Lee.

Alarm with Brake Light, ABS, VSC and amber warning lights ' PriusChat

priuschat.com > ... > Gen 2 Prius Care, Maintenance and Troubleshooting

Jul 26, 2005 - Later that same day - I started getting an alarm - as soon... ... Gen 2 (2004-2009) Toyota Prius Forums > Gen 2 Prius Care, ... Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by NorthStar, Jul 26, 2005. ... I am getting the red BRAKE LIGHT, the amber waming symbol, ABS, and ... VSC, ABS, (!) and emergency brake light on
Feb 5, 2010
Brake, Brake warning, ABS, VSC appear
Oct 5, 2008
More results from priuschat.com

toyota prius This is the most useful thing I think, to get manual so you can do it yourself anytime ! Check it out

run the fault codes to find out the faulty sensors /solenoids / servos.

One or more ABS sensors or ride-height sensors could be bad. You need specialized dealer-only scanner to read codes to determine actual problem if new 12 volt battery didn't solve it.

The clicking noise could be related to the bigger problem with the abs/vsc actuator, this is a kind of common problem on the prius models, the actuator should be replaced, this is a very expensive part (around $2000) for the part only, while the warning light is on the traction control and abs are disabled, it will still brake normally.

you need to have code erased using code scanner.any time replace sensor you have to erase code or check engine light stay on.

The problem may be the check engine light only, whenever it turns on the master warning light may also turn on, if there is an autozone or similar autoparts place close by you can go there and they can diagnose the check engine light using their scantool, then you can reply here to me with the code numbers and I can help, the code numbers are important so please write them down.

Take vehicle and have it scanned for codes. Something happened most likely a sensor went bad