SOURCE: 1998 ford contour fuse diagram
dont have an actual diagram but if you check at mastercraft.com they have a copy of the owners manual online and its free to access.
SOURCE: need a diagram for serpentine belt 1998 Ford Contour 4cyl 2.0l.
98 ford contour 2.0 belt routing
here is a picture of routing and how to do it , etc. , good resource ..
J5
SOURCE: How do I remove the front door panel to replace the mirror
Normal
0
Disconnect your negative battery cable. Locate and remove
the screws that hold your interior door handles in place (they may be hidden by
snap in, or snap on clips). Remove the interior door handles, then disconnect
the wire clips to the switches. Your panel is held in place by snap in clips;
use a small pry bar to pull them from the door (try to get as close to, or
directly under the clips to prevent them from tearing out of the door panel).
Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.
If you don't have power windows you will have to
remove the manual window crank. It is held in place by a clip on the back side
of the base. To remove the clip, you will need a small hook (kind of like a
knitting needle). Put the hook in behind the base, and grab the clip and pull
it off. To replace it, slide the clip back on the window crank, and snap it
back on the door.
SOURCE: 1998 safari van - removal of passenger internal door panel
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. then you just remove the bolts to the mirror
SOURCE: how to remove front driver side door panel (2000 ford expedition)
There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.
Visit The Official RAM Truck Site To View Photos Of The New RAM 1500.
www.RAMTrucks.com/1500
265 views
Usually answered in minutes!
×