1996 Nissan Altima Logo
A
Anonymous Posted on Oct 17, 2014

Why My driver side window wont go up on my 1996 nissan altima

All other window go up except the driver side what would i have to do or buy

1 Answer

MKford

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

  • Expert 115 Answers
  • Posted on Mar 18, 2015
MKford
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

New Friend:

An expert that has 1 follower.

Joined: Sep 16, 2010
Answers
115
Questions
0
Helped
37130
Points
167

You need to test whether you have power to your switch. If you do, you can test if the switch is working by checking to see if you have voltage coming out of switch to motor. If you have voltage coming out of the switch, your motor is most likely bad. If there is no voltage coming out of switch, the switch itself may be bad.

5 Related Answers

Anonymous

  • 55 Answers
  • Posted on Nov 11, 2008

SOURCE: DOOR WON'T OPEN FROM INSIDE OF NISSAN ALTIMA 2002 ON DRIVER'S SIDE

There is a cable that attaches to the inside door latch release handle. The plastic that retains this cable is most likely broken. I have seen this before. If the retainer is not holding the cable sheath correctly, the entire cable moves when the handle is pulled and does not release the door latch.

Remove the door panel and inspect this cable. You will see 2 cables (one is for the door lock). If the plastic is broken, you will need a new interior handle assembly.

Hope this is helpful!!



Nissan Scope Technician- 10+ years experience in Nissan dealership

Ad

Anonymous

  • 2 Answers
  • Posted on Nov 13, 2008

SOURCE: 1996 nissan altima power door lock (driver side

You may need to diconnect the power lock button on the driverside door by prying it out (with the window controls). Problem may be in the switch or a short in the wiring. If this is not it, it may be in the door switch on either the drivers or passengers door.

Anonymous

  • 43 Answers
  • Posted on Nov 13, 2008

SOURCE: remove driver's side door panel on 2002 nissan altima

Removal instructions are available with images and step by step directions, www.carstereohelp.com/strnissan.htm

Anonymous

  • 77 Answers
  • Posted on Jan 28, 2010

SOURCE: after it rains water is in trunk Nissan Altima

When diagnosing a water leak, here's a handy tip. Check the accumulated water. If the water is dirty, look for leaks from the underside of the vehicle (floor, wheelwells, etc). If the accumulated water is clean, look for leaks from the topside of the vehicle (trunk seal, window seal, etc). To find where the water is coming from, shut yourself in the trunk with a flashlight and have an assistant run water over the trunk with a garden hose. You may have to remove some of the interior trunk trim to see exactly were the water is coming from, but chances are you'll find it. Also another common cause of water leaks are from impact damage, so check for collision damage repair. while your in there. -hope this helps.

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Nov 11, 2010

SOURCE: I need an exploded view

Altima
Window Motor, Regulator & Switch - Removal & Installation

Front

zjlimited_56.jpg

Fig. View of power window components (click for zoom)

zjlimited_57.jpg

Fig. Locating window regulator

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the door speaker.
  3. Temporarily reconnect the power window switch to the door harness.
  4. Operate the power window switch to raise/lower the door glass until the door glass bolts can be seen.
  5. Remove the door glass bolts.
  6. Raise the door glass up into the door frame/channel and hold in place with a suitable tool.
  7. Remove the module assembly bolts and the module assembly.
  8. Disconnect the harness connector for the module assembly, and disconnect the harness clip from the back.
  9. To install, reverse removal procedure.

Hope helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1996 Nissan Altima Inhibitor Relay

Should be in the relay box behind drivers side headlight. Nissan part number 25630-9662. It has six pins.
0helpful
1answer

1994 Nissan Altima: Passenger side front power window will not go up or down. Passenger switch tested good but has no effect on window when connected. Was able to "hot wire" power window motor direct...

It can be either switch or any of the wiring in between. You have to follow a wiring diagram to test the circuit and this one is a bit complicated.
0helpful
1answer

Nissan Altima 96 doors wont stay locked.

REPLACE YOUR DRIVER SIDE DOOR LOCK MOTOR BEFORE YOU REPLACE IT DISCONECT IT FROM ELECTRICAL CONECTOR TRY LOCKING CAR IF IT WORKS THEN REPLACE THE LOCKING MOTOR LET ME KNOW MABY I CAN HELP IF YOU NEED ME TWO OK
1helpful
1answer

How do you jump the window motor to get it up on a 2003 nissan altima

There should be connection to the window motor inside the door panel. Disconnect it and run two leads from the battery.. One on negative one on positive. touch the leads from the motor with the leads from the battery. reversing the positive and negative leads, change the direction the motor turn.
0helpful
1answer

Fuse box diagram for 1997 nissan altima

According to wikipedia, the 1st-generation Nissan Altima was offered from 1992-1997. We have a 1996 nissan altima and attached is a photo of the inside of our fuse box. I also found another page that gives the same info for the 1997. I am sure this diagram would work for the 1992, 1993, 1994, 1995, 1996, or 1997 Nissan Altima.
https://www.2carpros.com/questions/1997-nissan-altima-lost-door-interior-fuse-box-turn-longer-diagram-could


1996_nissan_altima_fuse_box-e3etyfdk5gls3hpj0dvvvpy3-d-0_1.jpg
0helpful
1answer

1996 nissan altima brake light

it could be the socket or the wiring, get a test light anc check voltage at the socket, also check the ground wire,
0helpful
1answer

Nissan ALTIMA 2005

most of the time on nissans the driver window has a seperate relay by itself. look for that. next check for debris in the channels, it is possible that the switch is bad also.
0helpful
1answer

2005 nissan altima. replaced drivers air bag, front belts, and clockspring, all codes cleared except B1209 . roof airbags and pass. airbag did not depoly

You have to replace the air bag computer or have it reset,if you didnt they wont work,you can have it reset for about $60.00 myairbags.com
0helpful
2answers

1996 nissan altima power door lock (driver side

It may need to be ajusted..or an alarm is the proble..
Not finding what you are looking for?

216 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...