2005 Chrysler Pacifica Logo
A
Anonymous Posted on Oct 15, 2014

<!-- from fixya rte -->P0420 p0522 chrysler pacifica CODES - 2005 Chrysler Pacifica

2 Answers

carlos falero

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

  • Chrysler Master 1,327 Answers
  • Posted on Oct 16, 2014
 carlos falero
Chrysler Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Genius:

An expert who has answered 1,000 questions.

Joined: Apr 16, 2009
Answers
1327
Questions
2
Helped
348797
Points
2968

Thje po420 need to monitor o2 sensors to verify if you have a bad sensor or bad catalitic converter
the po522 oil presure sending unit

Thomas Perkins

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chrysler Master 15,088 Answers
  • Posted on Oct 15, 2014
Thomas Perkins
Chrysler Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Feb 12, 2010
Answers
15088
Questions
0
Helped
3386241
Points
54869
Ad

5 Related Answers

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Oct 30, 2009

SOURCE: 2004 chrysler pacifica air bag light on, no codes

dealer only be prepared for a bill of up to 2000euros

Ad

Jonah Oneal

  • 14092 Answers
  • Posted on Nov 25, 2010

SOURCE: By winodj_d on Nov 23,

CODE PO420 - CATALYTIC EFFICIENCY BELOW NORMAL BANK I POSSIBLE CAUSES - BASE ENGINE PROBLEMS HIGH COOLANT OR ENGINE OIL CONSUMPTION- CATALYTIC CONVERTER DAMAGED OR HAS FAILED - AIR LEAKS IN AT THE EXHAUST MANIFOLD OR EXHAUST PIPES -YOU NEED A CODE SCANNER TO ERASE CODE.

mike mountain

  • 1916 Answers
  • Posted on Apr 02, 2011

SOURCE: My chrysler pacifica had

catalytic converter is running below expected threshold-in other words, the sensor is telling the engine computer the cat is not doing it's job, that is to clean up any unburned gases going out of the exhaust. It can mean you need a new cat, or you have an exhaust leak-could also be cured with a new O2 sensor, or check the connection or wiring to the O2 sensor. Will not affect the way the vehicle runs, but usually indicates the car is not 'lighting off; (getting to operation temp) anymore.

FitzOriginal

Chris Hall

  • 842 Answers
  • Posted on Jul 25, 2011

SOURCE: what do these code means for my pacifica

P0513 is "Invalid Skim Key" The key may have damaged programing and if that is the case the dealer maybe able to reprogram that key for you (if you have 2 keys, both keys will have to be reprogramed so that they both match. Good Luck).
P0522 =Engine Oil Pressure Sensor/Switch Circuit Low Voltage.
Possible causes - Low oil level or motor mechanical fault
- Open or short oil level sensor circuit condition
- Poor oil level sensor electrical connection
- Faulty oil pressure sensor

chargerhp

chargerhp

  • 815 Answers
  • Posted on Dec 22, 2011

SOURCE: p0420 cod on crysler pacifica 2006

Two new o2 sensors. I use Denso

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Pacifica 2005 all wheel drive stuck in limp mode. codes p0420 catalyst effeciency below now normal. p0404 erg valve

: ( Dealer has the tools to properly diagnose these combinations of problems. Concern for the catalytic converter damage when operating under non normal closed loop operation.

The OBDII will try to protect the engine and driver by reverting to the limp home mode. Driving extended distance not recommended.

Dealer specific Chrysler analysis tools can pin point the problem allowing for problem resolution.


Hope this helps?
0helpful
1answer

Transmission

The P0522 is detected when the signal sent from oil pressure sensor to PCM goes below specifications.

Possible causes
- Low oil level or motor mechanical fault
- Faulty Oil Pressure sensor
- Oil Pressure Sensor harness is open or shorted
- Oil Pressure Sensor circuit poor electrical connection
3helpful
1answer

What is check engine code P0404 on a 2005 Chrysler Pasifica Touring?

The P0404 is EGR Position Sensor Performance. Changing the EGR should solve the problem. The labor time guide only calls for .7hrs to change, so it shouldn't be a problem to do this yourself. And the EGR should be able to be obtained from any local parts store (i suggest a better quality part store like NAPA as opposed to AutoZone)ae86d304-e024-412c-873b-0187d7589081.jpg
3helpful
1answer

P0420 cod on crysler pacifica 2006

Two new o2 sensors. I use Denso
0helpful
1answer

My 2004 Pacifica wont start at all, the gear is in park but the gears on my dash panel are all lit up, no matter what gear I put it in. I changed the Transmission Solenoid cause their was a hole in it...

What Transmission Solenoid did you replace ? Pressure control solenoid ? Shift control ? P0522 code is not saying oil pressure is low , It's saying the PCM is seeing sensor pressure low ! Do you know how to test automotive electrical circuits with a volt meter ? An this has nothing to do with your gears lit up . Different problem .
Not finding what you are looking for?

2,159 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...