How to change alternator 2005 chryler 300 - 2005 Chrysler 300

This answer covers:
2005 Chrysler 300 6cyl VIN "G" 3.5L SFI HO (72% of 2005 300's)
2005 Chrysler 300 6cyl VIN "R" 2.7L MFI DOHC (28% of 2005 300's)
2005 Dodge Magnum 5.7L engine

Alternator

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect negative battery cable.
3. Remove alternator drive belt.
4. Disconnect alternator field circuit plug.
5. Remove B+ terminal nut and wire.
6. Remove 2 lower mounting bolts.
7. Remove alternator.

1. Install alternator.
2. Install upper bolt mounting bolt.
3. Install 2 lower mounting bolts.
4. Tighten bolts to 48 ft. lbs. (65 Nm).
5. Install B+ terminal nut and wire. Tighten nut to 115 inch lbs. (13 Nm).
6. Connect alternator field circuit plug.
7. Install alternator drive belt.
8. Connect negative battery cable.

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect negative battery cable.
3. Remove alternator drive belt.
4. Remove bracket bolts.
5. Remove upper mounting bolt.
6. Raise and support vehicle.
7. Remove middle splash pan.
8. Disconnect alternator field circuit plug.
9. Remove B+ terminal nut and wire.
10. Remove lower mounting bolts.
11. Remove alternator.

1. Install alternator.
2. Install lower mounting bolts. Loosen install the upper mounting bolt.
3. Tighten lower mounting bolts to 48 ft. lbs. (65 Nm).
4. Connect alternator field circuit plug.
5. Install B+ terminal nut and wire. Tighten nut to 115 inch lbs. (13 Nm).
6. Install middle splash pan.
7. Lower vehicle.
8. Remove loose installed upper bolt.
9. Install bracket and bracket bolt.
10. Install upper mounting bolt and bracket.
11. Tighten upper mounting bolt to 48 ft. lbs. (65 Nm).
12. Tighten the bracket bolt to 40 ft. lbs. (54 Nm).
13. Install alternator drive belt.
14. Connect negative battery cable.

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect negative battery cable at battery.
3. Remove alternator drive belt.
4. Raise and support vehicle.
5. Unsnap plastic insulator cap from B+ output terminal.
6. Remove B+ terminal mounting nut at rear of alternator. Disconnect terminal from alternator.
7. Disconnect field wire connector at rear of alternator by pushing on connector tab.
8. Remove alternator support bracket nut and bolt. Remove support bracket. See Figure 1.
9. Remove 2 alternator mounting bolts. See Figure 2.
10. Remove alternator from vehicle.