Question about 2014 Chrysler 200

Open Question

Find the IAT/MAF sensor on a 2014 Chrysler 200 with a 3.6 liter VVT engine?

2014 Chrysler 200 with a 3.6 liter VVT engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 65 Answers

SOURCE: IAT MAP MAF pics & locations

Go to alldatadiy.com and buy the car you are working on and you will have access for a year. This should have mechanical illistrations of what you are looking for. By the way that car does not have a MAP sensor.It uses a mass air flow sensor. Hope this helps...Dan

Posted on Jun 21, 2008

Ad
  • 218 Answers

SOURCE: 98 Sentra IAT Sensor Location

IT IS ON THE HOSE THAT BRINGS AIR INTO THE AIR FILTER HOUSING

Posted on May 13, 2009

Molson02536
  • 3854 Answers

SOURCE: installing chip and want to double check wiring. Need to find IAT/MAF sensor diagram for 2003 Ford Ranger

Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.

Posted on May 29, 2009

  • 3600 Answers

SOURCE: MAP or MAF Sensor Diagram for 2005 Town&Country Touring Van 3.8l.

Yes it has a sensor and they are color coded however I don't think it's called a maf or map sensor that’s a GM name, there would be three wires on it on ground one 5 volts reference and one for connection to the computer to tell the computer how much air flow there is, and the reading would be from 1.5 volts to 4 volts.

Posted on Jun 22, 2009

  • 225 Answers

SOURCE: LOCATION OF -ATC(MAF/IAT) & CTS SENSORS-2007 nissan frontier 4.0

maf is mass air flow sensor, it is on the air filter box, iat is intake air temp sensor, should be in the tube from the air filter box. don't know what atc and cts are sorry. best of luck

Posted on Aug 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I find the IAT/MAF on my 2014 mini cooper S 2.0L engine and how do I determine which two lead to the sensor?


I'm pretty sure iat is part of the maf sensor which is located on the air filter and a 5 wire plug

Jan 24, 2015 | Mini Cars & Trucks

1 Answer

My 2004 fi50 has code po113 i just change the vct sensors


i moved you to F150 (ok/?) 5.4liter or what?
now you can get Ford answers and not Toyota.side show.
did you reset all DTCs after the service? (always 1st step)

VCT (or VVT in generic form)
is tricky.
in fact id never assume the sensor is bad first. (id clean them an believe them)
p0113 is IAT sensor open. (if unplugged key on, bingo)
are you using a scan tool that can see all FORD codes???
id bet not but if are, then there are many VVT codes.


Trouble Code Conditions: verbatum FSM.
Key on or engine running; and the PCM detected the IAT sensor signal was more than the self-test maximum 4.60v (Scan Tool reads under -46F). This is a thermistor-type sensor with a variable resistance that changes when exposed to different temperatures.
Possible Causes:
  • IAT sensor signal circuit is open (inspect wiring & connector)
  • IAT sensor signal circuit is shorted to VREF (5v)
  • IAT sensor is damaged or it has failed

my guess is doing service key on with IAT unplugged.

Jul 03, 2014 | Ford F-150 Cars & Trucks

1 Answer

I need to locate the iat for 2012 Ford Triton V-10 6.8 liter plus wire colors for the two wires that supply the iat


That sounds like a Mass Air Flow sensor. Why are you checking it? What are your symptoms? Make sure your air filter is clean.

Aug 18, 2017 | Cars & Trucks

1 Answer

What color is the iat sensor on a 2008 Saturn Outlook XE 3.6L v6 VVT


The intake temperature sensor is part of the mass air flow meter which is the black box mounted between the air filter and inlet tube. If you are getting a code for IAT, you need a MAF.

Aug 11, 2012 | Saturn Cars & Trucks

1 Answer

Which are the functional iat sensor wires on an accordd 2008


It all depends on which engine your Accord is equipped with. This is really nice-to-know information when you are asking somebody for help with your engine control circuits.

For the 2.4L engine: At the MAF/IAT sensor connector, Pin #4, GREEN/BLACK is the "sensor ground" and Pin #5, RED/YELLOW is the "sensor input" for the IAT.

For the 3.5L engine: At the MAF/IAT sensor connector, Pin #1 GREEN/YELLOW is the "sensor ground" and Pin #2 RED/YELLOW is the "sensor input" for the IAT.

Oct 04, 2011 | 2008 Honda Accord

2 Answers

Maf/iat sensor location 99 concorde and wut wires are the power wires?


9_23_2011_11_54_17_pm.jpg


9_23_2011_11_56_25_pm.jpg

This vehicle has MAF or IAC sensors - not ?? MAF or IAT ??

Which do you need the wiring for?

Sep 23, 2011 | 1999 Chrysler Concorde

2 Answers

I need to find the intake air temperture sensor in my dodge


depends on the engine...
3.7 liter, #1 below:

jturcotte_112.jpg

4.7 liter:

jturcotte_113.jpg

5.7 liter, #2 below:

jturcotte_114.jpg

Jan 01, 2011 | 2006 Dodge Ram 1500

1 Answer

2007 GMC 2500HD. TRYING TO FIND WHERE THE IAT SENSOR IS LOCATED. Is this on the lower left side of your truck under the hood. Does this have a 5 wire plug into the MAF?


Hello mahnkes.

You did not mention what engine you have.
I have based this reply on a 6.0 liter gasoline engine.

The IAT (intake air temperature) is integral with the MAF that is mounted in the intake duct and if defective will need to be replaced as an assembly.
#2 in the diagram below.

f470717.gif
I hope this helps you along.
Let me know if your engine isn't the 6.0

May 01, 2010 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

My maf sensor pigtail was cut and stolen. I purchased a new pigtail from ford and I need to know the color codes so I can intall a new one. my vehicle is a 2004 ford f-150 lariat with a 5.4 liter engine....


As long as you are talking about the new body style ( 3V 5.4 L )

The module is the MAFS and the IAT sensors

The IAT section is :
PCM to IAT is Gray wire
The return to the electronic engine controls from the IAt is Gray w/ REd stripe wire

The MAFS
PCM to MAFS ( MAF ) is Light Blue w/ Red stripe wire
The MAF return on the PCM is Tan w/ Light Blue stripe wire
The ground ( same as the Charge motion control valve ) is Black w/ White stripe wire.

Apr 01, 2010 | 2004 Ford F150

Not finding what you are looking for?
2014 Chrysler 200 Logo

Related Topics:

439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...