Question about 2000 Chrysler Town & Country

Open Question

Electrical current not getting to transmission Chrysler 2000 town and country

Won't go beyond 2nd gear, odometer not working, speedometer not working, changed 1 module in transmission, still not working

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
garyq1970
  • 85 Answers

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Posted on Aug 24, 2008

Ad
godspeed808
  • 125 Answers

SOURCE: 2002 Chrysler Town & Country Speedometer does not work

your vehicle is equipped with a speed sending unit and that must be faulty and need changing it is fairly expensive and usually only the dealer carries it but I know a good salvage lot in Oregan might have it cheaper heres there number Peach street autorecycling 18003652341 good luck and dont forget to rate this if I helped.

Posted on Feb 04, 2009

csmock132
  • 4669 Answers

SOURCE: 2003 chrysler town and country speedometer quit working

It is the speedometer that doesn't work? What problem do you have? Does the transmission shift or is it stuck in 2nd?

Posted on Mar 02, 2009

emissionwiz
  • 84966 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

  • 1 Answer

SOURCE: country speedometer doesn't work and won't shift out of 1st gear

transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.

Posted on Jun 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my speedometer and odometer stuck at zero?


Could be a problem with the engine computer, or the speed sensor in the transmission.
Is the check engine light on ?

Jun 25, 2013 | 2000 Chrysler Town & Country

1 Answer

Speedometer not working


Could be the speed sensor on the transmission or the speedometer on the dash. Does the odometer work ?

Dec 09, 2012 | 2002 Chrysler Town & Country

1 Answer

1997 Chrysler Town & Country, codes; p1698, p0734, p1782, p1788, p0732, p1787, and p0700? Plz help


You will need the help of a transmission repair shop or the dealer, there is a serious transmission problem and it will require special test equipment and training to find the cause, which is likely a wiring harness issue.

Aug 06, 2012 | 1997 Chrysler Town & Country

1 Answer

I notice that sometimes my 98 chrysler town an country jumps from 1st gear to 2nd gear to soon. Does that mean that my transmission is starting to go out?


If it is only happening sometimes, you should get your transmission serviced ASAP. If you do this you should be able to save the transmission.

May 19, 2010 | 1999 Chrysler Town & Country

1 Answer

Country speedometer doesn't work and won't shift out of 1st gear


transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.

Apr 17, 2009 | 2001 Chrysler Town & Country

1 Answer

2003 chrysler town & country speedometer stuck


sit in the drivers seat close the door. with the key off hold the trip odometer button in then while holding the button in turn the key on. if done correctly this will put the MIC (mechanical instrument cluster) into a self test. if the speedometer does not move like the rest of the gauges during this test the MIC must be replaced. if the speedometer does move it is likely your problem will be fixed, however, if the speedometer does move but it does not start working properly then further diagnostic will be needed.

Mar 19, 2009 | 2003 Chrysler Town & Country

1 Answer

2003 chrysler town and country speedometer quit working


It is the speedometer that doesn't work? What problem do you have? Does the transmission shift or is it stuck in 2nd?

Mar 02, 2009 | 2003 Chrysler Town & Country

1 Answer

Everything on dash panel not working.


Fuse for the instrument panel is possibly blown. Check your owners manual for the proper location of the fuse. If you do not have a manual they are available online in PDF version.

Jan 09, 2009 | 2000 Chrysler Town & Country

Not finding what you are looking for?
2000 Chrysler Town & Country Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

84966 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...