Cars & Trucks Logo
A
Anonymous Posted on Oct 09, 2014

Where is the ad know located on 2006 Chevrolet equinox?

I am trying to reset my clock in my 2006 Chevrolet equinox, I am unable to find the adj knob. Can you help me by telling me where the adj knob I at that kind you.

1 Answer

DAVID LANE

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Oct 11, 2014
DAVID LANE
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Sep 25, 2013
Answers
2
Questions
3
Helped
1056
Points
2

Push clock button top right your hour should blink then use your radio tuning knob to adjust hrs. push clock button again to switch to minutes and use tuning knob again to adjust minutes once set just press the clock button to enter

5 Related Answers

Jamie F

  • 98 Answers
  • Posted on Dec 18, 2008

SOURCE: 2006 Chevrolet Equinox Driver's door will not open the door

Sounds like the release rod came off of either the main latch or the inside release handle. My guess would be the latch since I don't see many problems with the inner handles. To check you have to remove the door panel. Follow the rod to the latch area. There should be a plastic type of clip that the rod came off of in the general area of the end of the rod. The rod may just push back into place.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 19, 2009

SOURCE: I need to reset my computer on a 2006 chev equinox

there are 2 ways to do this, use a scan tool ($50 for a basic one) to reset the light, the other is to disconnect the battery for 5-10 minutes, be advised if the problem is not corrected that set the light the light will come back on in about 20 miles, also if the system is not ready u will fail smog, this means they (person doing the smog) know there was a problem.

Anonymous

  • 15 Answers
  • Posted on Aug 25, 2009

SOURCE: Ac Freeze Up

relays are ether under hood in fuse box or under dash fuse box most cars have a diagram on the cover of said box... they look like a 1"x1" cube they have 4 or 5 prongs or blades on the bottom....

Anonymous

  • 1450 Answers
  • Posted on Mar 11, 2010

SOURCE: The cruise control on my 2006 Chevrolet Equinox

I have repolaced a couple switches on these does yours show power when you cut on but will not engage ? if so probably the set/resume switch on steering wheel

roniecon

Ronny Bennett Sr.

  • 6988 Answers
  • Posted on Apr 21, 2010

SOURCE: 2006 Chevrolet Equinox won't start, security

Make sure the doors and trunk,and hood are shut,open them,and shut them .activate the anti theft,wait about 1 minute,and disarm it,see if it will start,if not,the key fob may need to be relearned,try turning the key on,leave it ten minutes,then turn it off,and right back on,then wait ten minutes,and turn it off,and right back on,do this a total of three times,,30 minutes,then try and start.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Where is the fuel pump for 2006 Chevy equinox located end can I change it without having to drop the tank

you can google your question.
try 2006 Chevy equinox fuel pump location
About 6,820,000 results (0.48 seconds)
https://www.youtube.com/watch?v=e-BKPWabveE
0helpful
1answer

Change clock on Pontiac g6

There is 2 different radios. With or without rds. Here are the instructions for both.
Setting the Time for Radios with Radio Data Systems (RDS) To set the hour, press the clock button. The clock symbol displays and the hour flashes. Turn the ADJ (adjust) knob to increase or to decrease the hours. To set the minutes, press the clock button again. The minutes. Turn the ADJ knob to increase or to decrease the minutes. The time can be set with the ignition on or off.
To synchronize the time with an FM station broadcasting Radio Data System (RDS) information, press and hold the clock button to enter the clock set mode, then press and hold the clock button for three seconds until UPDATED displays. If the time is not available from the station, NO UPDATE displays.
RDS time is broadcast once a minute. After tuning to an RDS broadcast station, it can take a few minutes for the time to update.
Setting the Time for Radios without Radio Data Systems (RDS) To set the hour, press the clock button. The clock symbol displays and the hour flashes. Turn the ADJ (adjust) knob to increase or to decrease the hours. To set the minutes, press the clock button again. The minutes flash. Turn the ADJ knob to increase or to decrease the minutes. The time can be set with the ignition on or off.
0helpful
2answers

I can not figure how to set the clock in my 2005 vhevy equionox

Look for two small buttons one has h one has m push and hold
0helpful
1answer

Where is the adj know located on 2006 Chevrolet equinox?

if no hr/min button, seek/scan is usually hr/min
0helpful
1answer

2006 Chevy Equinox Heater not working

Could you be more specific on what was fixed? and i would start by checking your fuses, do you hear any sounds when turning all the knobs? sometimes you can hear the heater flaps moving around when adjusting temp, the fuse for the fan probably is blown.
0helpful
1answer

I got a chevy equinox 2006 everytime I start it the clock resets to 12? What is the problem?

the clock must supply directly from the battery , if no anytime when you switch on and of the clock come back to 12 and lose the memory.Is not difficult but need time to find the wire from clock and connect to an permanent 12 volt supply somewhere on the board , consumption is very small few miliamps.
5helpful
1answer

How do I set the clock in my 2006 Equinox... nothing in the manual

check page 3-39

Setting the Time
To set the hour, press the clock button. The clock
symbol will appear on the audio display and the hour
number will flash. Then turn the ADJ knob to increase or
to decrease the hour. To set the minutes, press the
clock button again. The minute numbers will flash.
Then turn the ADJ knob to increase or to decrease
the minutes. The time can be set with the ignition on
or off.
To synchronize the time with an FM station broadcasting
Radio Data System (RDS) information, press and
release the clock button to enter the clock set mode,
then press and hold the clock button for three seconds
until UPDATED appears on the display. If the time
is not available from the station, NO TIME UPDATE will
appear on the display.
RDS time is broadcast once a minute. After tuning to an
RDS broadcast station, it may take a few minutes for
the time to update.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

0helpful
1answer

How to change the time on the clock

Without Radio Data Systems (RDS): To set the hour, press the clock button. The clock symbol will appear on the display and the hour number will flash. Then turn the ADJ knob to increase or todecrease. To set the minutes, press the clock button again. The minute numbers will flash. Then turn the ADJ knob to increase or to decrease. The time can be set with the ignition on or off.
With RDS: Same as without RDS unless you want to Sync. with a radio station. To synchronize the time with an FM station broadcasting Radio Data System (RDS) information, press and hold the clock button to enter the clock set mode, then press and hold the clock button for three seconds until UPDATED appears on the display. If the time is not available from the station, NO UPDATE will appear on the display. RDS time is broadcast once a minute. After tuning to an RDS broadcast station, it may take a few minutes for the time to update
0helpful
1answer

"06 chevy equinox how to reset security system. engine light on abs light on and break light on the radio clock turns to 12:00 everytime when turning the key

Take + terminal off the battery and leave it sit for 2-3 mins. This act's like a reset-to default factory settings...I had same problem on my 97 Z28, endeded up being the negative terminal to the battery was just slighly loose. I noticed it while disconnecting the the battery to reset my ob-cpu...Try this and let me know if it worked... i should!
2helpful
1answer

I need to reset my computer on a 2006 chev equinox

there are 2 ways to do this, use a scan tool ($50 for a basic one) to reset the light, the other is to disconnect the battery for 5-10 minutes, be advised if the problem is not corrected that set the light the light will come back on in about 20 miles, also if the system is not ready u will fail smog, this means they (person doing the smog) know there was a problem.
Not finding what you are looking for?

188 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...