SOURCE: 2000 NISSAN FRONTIER VIBRATION
Check tire balance, rear wheel bearings and i would replace u joints front and back, anyway if they have never been repaced.
SOURCE: how to install a brake light switch 2000 for a
look up above your brake pedal and you should see the switch. Depending on the car, the switch either pops out, or just needs a screw to be removed
SOURCE: I need to know where brake switch is on a 2002
under the dash, follow brake pedal up,you will see switch near the top.
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
40 views
Usually answered in minutes!
×