Need to find a diagram and where the crank sensor is located and how to replace it
SOURCE: location of the speed sensor on 1996 town & country
they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff
SOURCE: where is the body control module located on a 1997 town & country
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: 2005 crank position sensor location
The crank shaft sensor on that model should be on the driver side towards the back of the tranny its not hard to get to.
SOURCE: I need to recharge my air condition on 2006 town & country van
UNLESS YOU HAVE A MACHINE TO RECHARGE THE A/C THEN DO NOT ATTEMPT TO PLAY WITH A VERY DANGEROUS SYSYEM. This is a specialised piece of kit and without the right machine to do the job you could end up with serious injuries
259 views
Usually answered in minutes!
×