SOURCE: LOW BEAM LIGHTS
Hi Rich Million,
Check the bulbs for the low beam problem and if they're ok, check the fuses under the bonnet (hood) which are found in the fuse box. If you've already checked those, go to the fuse box inside the vehicle.
Still no luck....remember that there are fuses and relays inside the cabin behind the kick panel.....You may find that there is a problem with the main fuse box.....If you drive over rough terrain, check the connections under the main fuse box....even if your roads are all smooth, it's still worth checking.....
Regards Johngee10
SOURCE: passenger side headlight only works on high beam.
If you put it in; did you touch the bulb with your fingers? If so, I've seen bulbs pop as soon as they're put in. The oil from your skin leaves a residue, and the heat goes to it, and blows the bulb. wear jersey or latex gloves when you re-install new bulb. If it still doesn't work, replace headlight bulb socket
SOURCE: low beam drivers side doesn't light; high beam
Looking at the diagram, you dont say if you car has Daytime Running lights or not. The Black/White wire is gounded to make the low beam work. Ground that wire to confirm if the socket and bulb is good. If you ground the wire and the bulb works, there is a juntion block where the wire turns frm Black/white to Red/blue but I donr know how to tell you where it is. The headlight switch may be bad.
SOURCE: 2001 Corolla with daytime running
One thing that will kill these particular bulbs faster than anything is, oil from your hands. Use latex gloves when installing these kinds of bulbs. Look at the socket for any signs of damage or excessive heat. Replace with a quality bulb and let me know if you find something while changing the bulb.
SOURCE: Daytime Running Lights Inoperative 2002 Toyota Camry
[Information] For a 2002 Toyota Camry, the Daytime
Running Lights (DRL) operate utilizing the High Beams (inner Lamps closer to
the center of the vehicle front) at a reduced power. [The troubleshooting process:] Review the Owner's Manual and ensure the test
configuration matches the following criteria: 2. Set the Test Conditions according to Step 1 above. 3. Check the headlight bulbs to ensure they are not
burned out. If one burns out, there is a fair chance that the other would have burned
out at the same time. Replace as necessary.
In this case, if the high beams operate, the DRLs should also operate. My problem was that the test configuration did not have
the engine running and parking brake off - Step 1. Problem solved with much
thought, repetitive tests on the vehicle and going back to the basics -- what
does the Owner's Manual say and where are the applicable fuses and relays
located?
1. According to the 2002 Toyota Camry Owner's Manual (Check your Owners Manual):
"The DRL system will make your headlights come on at a reduced brightness
when:
The light switch s in the "DRL" position.
The ignition is on with the engine running.
The headlight switch is off.
The parking brake is released."
4. Test the system, ensuring the step 1 conditions are set. (Engine running, Multi-function
Switch on Turn Signals in "DRL" position, headlight switch off
(repeating what the manual says -- it should be obvious that in the
"DRL" position, the headlight switch should be off / do not have the
switch positioned to "High Beam"), and the Parking Brake
"off").
5. If DRL lights do not work, check the engine compartment Fuse and Relay Box.
there is a 5 Amp DRL fuse -- replace it with the spare. Test (step 4).
6. If it does not work, swap around or replace relays -- there are three (3).
Any one of them could be bad (stuck or burned out). Test (step 4).
7. Other less likely possible issues
could be that the Multi-function Switch is broken or a connection / wire is
broken. [Beyond the scope of this
process.]
146 views
Usually answered in minutes!
×