SOURCE: Drivers Power door lock?
the most common fix for this is what is called the accuator that must be replace it is part of the latch assembely
SOURCE: How to program keyless remote
I just had to buy one too and these are the instructions I was given by the guy I bought it from. I haven't tried them yet. Hopefully they work for us both :).
1.Find the ETACS unit under the steering wheel first,there is a small switch onit.
2.Once the switch is located make sure your key is not in the ignition and set the switch from off to set.
3.Press keyfobs door lock button for one second, this sends the codes to the ETACS and stores it.
4.Do the same thing if you have 2 remotes for the vehile.
5.Now set the ETACS switch from set to off.
6.Remotes should now be programed.
SOURCE: The rear hatch on my 2003 Hyundai Santa Fe won't stay up.
Yes. Your Local Auto Parts Store should Carry these as Direct Replacements. If Not, Sears Carries them.
SOURCE: how to remove door panel from hyundai santa fe
A door panel removal tool works best, but if you have a stiff putty
knife about 4" long and 1 1/4" wide it will work if you are careful.
Start at the bottom of the panel and work your way around. Insert the
blade all the way in between the panel and the door with the edge of
the blade right next to the plastic fastener. Then pull the tool handle
away from the door slowly. It will take a bit of pressure to get the
first one or two clips to release.
The other steps I follow to remove this panel are as follows:
1. Remove the screw in the trim behind the door handle and then remove the trim piece.
2. Remove the door release cable from the handle.
3. Remove the door handle mounting bolts and then remove the handle.
4. Remove the three door panel mounting screws: 2 on the back edge of the panel and 1 in the door pull cup.
5. Separate the panel edges from the door. (see above) Lift the panel
up starting with the back edge first to free the top lip of the panel
from the door.
6. Disconnect the electrical connectors from the switches and light.
(You may need a very small flat blade screw driver to depress the
locking tabs on the switch connectors.)
plz rate this solution as i have a whole page of unrated posts, thanks
928 views
Usually answered in minutes!
×