Select total mileage on you odometer with the trip odo button. turn the ignition key OFF push the trip reset button and hold wile turning ignition ON. the display will show --------- and one bay one will delete hold till the last one is gone and release the reset button.now the maintenance is reset to zero.
SOURCE: maintenence light
I get many calls a week for this procedure...
This is really easy! Follow these directions:
Turn the key ON
Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.
Turn the key OFF.
Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.
Turn the key ON; do not start the car.
Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.
Release the black trip meter reset stick.
This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.
Hope this helps!
SOURCE: Reset the maintenance required light on my 2008 toyota corolla
OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..
SOURCE: How do i reset the maintenance required light
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 145 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset knob.
Hold down the knob for at least 5
seconds. The odometer indicates “000000”
and the light goes off.
If the system fails to reset, the light will
continue flashing.
To reset the Maintenance Lamp turn the car key to ON (not start), set your odometer on mileage (not trip a or b), then depress and hold the button that switches from odo and trip then turn key off. Turn the key back to ON, while you are holding the button down you will notice the maintenance light blink and go out. Reset is complete and you are done.
These are available in your owners manual for the vehicle.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: toyota tacoma 2003 check engine light is
If the car still runs then the problem is not major but may develop into one if unchecked. The sensors in the engine may have detected problems and should be stored in its ECU. If you have a scanner have it connected to the diagnostics it should give you a clue on what to check out.
SOURCE: how to wire trailer lights to a toyota tacoma
The easiest way is to get the kit that plugs into the taillight harness to adapt your plug. If one isn't easily available then you can use scotch locks to splice into your trucks harness. Use a test light to make sure you locate the right wires in your trucks harness and go by the wire diagram on the instructions from the plug to hook it up.
I hope this helps!
308 views
Usually answered in minutes!
×