I have a 2003 monte carlo. had the tint remove from back windo. the tab on the grid came off but the mechanic replaced it. now when I listen to my radio if I turn on the defogger it messes up my radio

Normally under the rear passenger seat. conflicting details here

Fuel pump replacement - Monte Carlo Forum

Monte Carlo Forum https://montecarloforum.com > forum > fuel-pump-re...
Apr 29, 2017 - You are correct, there is an access in all 2000-2005 Montes for the fuel pump in the trunk. It is under the carpet in the trunk between the spare tire well ...
2002 Monte Carlo Fuel pump location?
Apr 26, 2017
tips for replacing fuel pump/droping the tank
Aug 31, 2011
More results from montecarloforum.com

2005 Chevrolet Monte Carlo Fuel Pump Replacement Prices ...

Kelley Blue Book https://www.kbb.com > chevrolet > fuel-pump-replacement
A mechanic will need to get to the failed pump through the top of the fuel tank via an access panel in the passenger compartment or by removing the tank from ...

Question edited for clarity and add maker.
Question moved to model forum.

Interior Light Removal - Monte Carlo Forum

https://montecarloforum.com > monte-carlo-repair-help-8
Jul 10, 2009 · 4 posts
If you look closely at the edge of the clear plastic there is a tab on one side and two on the other. Just take a flat headed screwdriver (or ...
Dome light lense removal. - Monte Carlo Forum
Dec 15, 2009
Repair Guide: How To: Change Dome Light in 6th Gen
Sep 16, 2009
changing interior lights - Monte Carlo Enthusiast Forums
Feb 2, 2009
How to turn dome/interior lights off! - Monte Carlo Forum
Apr 26, 2017
More results from montecarloforum.com

• You have to remove the hub bearing assembly and press them out and then back in. DO NOT USE A HAMMER!!!! A stud press works the best. If I was doing the job and the car has a number of miles on the old hub bearings I would just replace the whole assembly with new ones. They have new studs already installed. www.rockauto.com is a good site to get that kind of stuff. Happy Mechanicing!!

If the code is 301 it means there is no power from that cylinder. It could be a problem with the ignition, fuel injector, or something mechanical.

There is no adjustments on the 2003 Monte Carlo. The bushings in the hinges are worn and the whole hinge will need to be replaced.

Best is to replace the upper and lower hinge. It takes just under an hour with a helping hands to remove the both hinges, but replace them one at a time.

Thank you for using Fixya and be safe.

Seems like you are not getting enough current to make it work properly. Check for bad connection, burnt connection, corroded connection etc. Maybe the contact to the relay is worn as well.

If its broken then it is advantageous to replace it.

you can either remove the steering pump to gain access,if there is no holes in PS pump pulley,you can rent a pulley puller....can be a ***** to get in and use them though....I will drill a hole in it for next time whenever I replace a pump on cars without ....

IF I REMEMBER CORRECTLY YOU HAVE TO REMOVE THE WHOLE LIGHT TO REPLACE THEM. ON THE BACK SIDE OF THE LIGHTS ARE 2 RODS THAT CAN BE PULLED UP TO RELEASE THE LENS. THERE ARE SLOTS ON THESE RODS AND TABS ON THE LENSES. LINE THEM UP AND THE LIGHT SHOULD COME FORWARD. HOPE THIS HELPS. LET ME KNOW. GOOD LUCK.

I would try going to one of your local auto parts places first and ask them to hook up a codes scanner and see if there are any codes. If so, which ones and fix the first code first. That will usually fix any other codes as well.

Kenneth Triest