Removal of starter on 2000 saturn

SOURCE: trying to remove the starter on a 1991 SaturnSL

no there is not a special tool need more info go to collisionrepairadvice.com for more
1991 Saturn SL L4-1.9L DOHC VIN 7 Vehicle Level Starting and Charging Starting System Starter Motor Service and Repair Service and Repair Notes

1. Disconnect battery ground cable.
2. Remove air inlet tube and fresh air hose, on DOHC models, lift resonator upward to disengage from engine support bracket.
3. Remove upper starter attaching bolt through access hole near intake manifold support bracket.
4. Raise and support vehicle.
5. Using suitable pliers, remove starter shield pin, then lift shield upward to release from solenoid.
6. Disconnect starter electrical connectors and position aside.
7. Remove lower starter attaching bolt.
8. Remove rear starter support bracket attaching bolt.
9. Rotate starter until bracket clears axle shaft support bracket, pull rearward toward lefthand side of vehicle to remove.
10. Reverse procedure to install. Torque starter attaching bolts to 26 ft. lbs., starter bracket bolts to 22 ft. lbs. and starter solenoid terminal to 3 ft. lbs.

SOURCE: 93 saturn twin cam starter removal

Top bolt is almost dirrectly above bottom bolt but,toward engine about 1 inch. slip 13mm.socket with enstention behind starter solenoid ,you have to fish for this bolt.Very hard if you do not have a rack,We always remove it from bottom.

ZJ Limited

• 17989 Answers
• Posted on Oct 20, 2009

SOURCE: need to remove radio in 2000 Saturn SL 2 need to

In here you can find tips about All Saturn - Remove Radio

Hope helped (remember rated this help). Good luck.

SOURCE: I am trying to get a starter off 2000 saturn LS2

I am trying to get a starter off 2000 saturn LS2 and i can't get to the bolts Do i need to remove alternator or somehting else. and what size female torx is it mounted with