Where is the fuel pump sensor located for a 1993 ford tempo?

SOURCE: Finding were a filter is

On these vehicles, the fuel filter is located on the fuel line to the carburetor. Special care should be taken when removing and installing the fuel filter, not to bend or distort the fuel line in any way.

1. Remove gas cap to relieve any pressure that may be present in the fuel system.
2. Remove the air cleaner bonnet assembly.
3. Using a backup wrench on the return line fitting on the top of the fuel filter, remove the fuel line with a flare nut wrench.
4. Using a backup wrench on the fuel filter inlet fitting, remove the fuel line from the fuel filter with a flare nut wrench.
5. Using a backup wrench on the fuel filter outlet fitting, loosen the fuel line and remove the fuel filter from the engine with a flare nut wrench.

1. Apply a drop of engine oil to all the fuel line nuts and flared ends.
2. Position the fuel filter with flow arrow on the filter directed towards the fuel line going to the carburetor.
3. Finger-tighten the fittings at the fuel filter outlet, inlet and return line into the top of the filter.
4. Using a backup wrench on the fuel filter fittings, tighten the fuel lines in the following sequence:
   1. Tighten the outlet and inlet line nuts to 15-18 ft. lbs. (20.0-24.0 Nm)
   2. Tighten the nut on the return line at the top of the filter to 6-9 ft. lbs. (15-18 Nm).
5. Inspect the fuel lines and carefully adjust if they are interfering with the carburetor, air pump, or fuel filter housing.
6. Start the engine and check for fuel leaks at all the connections. Retighten if necessary.
7. If removed, install the air filter bonnet assembly.

SOURCE: 1992 ford tempo water pump replacement

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528005d60d

SOURCE: Fuel Pump Relay for 1993 Ford Tempo

it is in the trunk on the left hand side, pull away the trunk carpet on left side and you will see a hole with a top and bottom screw remove the screws and pull the relay out threw the hole, then disconect the wiring connector When you plug the relay back in turn on key you should here the pump run for a few seconds if it does not then replace the relay ,or the pump.

Marvin

• 85242 Answers
• Posted on May 12, 2010

SOURCE: where is the fuel pump relay on a 1992 ford tempo?

The fuel pump relay is part of a large relay control unit called the IRCM (intagrated relay control module)

The module is about 6"x4"x2" and has gobs of wires (large retangular connector) coming out of it, the module is mounted on a bracket under the hood that is bolted to the top of the driver's side front strut tower, this module can be self tested by a dealer to see if it is bad, they seldom fail, I am a Ford dealer tech and have only replaced 2 in 20 years, Tempo does however have a fuel pump issue..

SOURCE: where is the fuel pump relay for a 1993 ford tempo

Hi :) The fuel pump relay is an integral part of the body control module it also houses the Fan relay this module is about 6"x4"x2" and has gobs of wires coming out of it, the module is mounted on a bracket under the hood that is bolted to the top of the driver's side front strut.